Adapteri BitsPower X-Cross G1/4 inch ulkokierre G1/4 inch sisäkierteeseen, 5 mm siirto, valkoinen

BitsPower X-Cross G1/4" male to G1/4" female adapter with a 5 mm offset in white is a compact fitting designed for PC liquid-cooling systems. It converts a standard G1/4" male thread to a G1/4" female thread while introducing a small lateral displacement to reposition tubing or components. The adapter is intended to simplify routing in tight spaces, reduce bending stress on soft or hard tubing, and provide a tidy connection where a slight offset improves alignment.

Advantages

The adapter provides a precise 5 mm offset that helps avoid interference between nearby components and enables neater tubing runs without major alterations to existing ports. Its standard G1/4" compatibility ensures broad use with most water-cooling blocks, radiators and fittings. The compact white finish blends with light-coloured builds and offers a low-profile solution that maintains the original thread engagement while shifting the connection point.

Suitable for

• Repositioning tubing to clear adjacent components in PC liquid-cooling loops
• Reducing stress and sharp bends on soft or hard tubing
• Connecting fittings where a slight offset improves alignment or aesthetics
• Compact or custom builds that require precise port displacement

Key specifications

• Thread conversion: G1/4" male to G1/4" female
• Physical offset: 5 mm lateral displacement
• Colour: white finish
• Compatibility: designed for standard G1/4" water-cooling ports and common soft/hard tubing fittings
• Form factor: compact, low-profile adapter

How to use

Ensure the mating port and adapter threads are clean and free of debris. Hand-start the male thread into the port to avoid cross-threading, then tighten until snug using appropriate hand force or a suitable tool if required—do not overtighten. Attach the tubing or downstream fitting to the female thread and verify correct alignment achieved by the 5 mm offset. After installation, check for leaks at operating pressure and retighten if necessary following manufacturer torque guidance for your fittings.

Recommendations

Use with standard G1/4" sealed fittings and compatible tubing. Inspect O-rings or seals on mating components and replace if damaged. For hard tubing bends, allow for the offset when planning cut angles to avoid stress concentration at the joint.