HP USB- ja virtapainikepiirilevy L44578-001 sisäinen I/O-piirilevy HP-kannettaviin

Replacement internal I/O board for compatible HP laptops that integrates a USB port and the power button interface. The HP USB and power button board L44578-001 is intended for technicians and experienced users performing hardware repairs or board replacements to restore USB connectivity and front-panel power control after damage or failure.

Advantages

This internal board combines a USB connector and the power-button circuitry in a single compact module, allowing targeted repair without replacing larger assemblies. The component matches original HP design and connectors for straightforward installation on compatible models, ensuring correct alignment of ports and button interface. Using a direct-replacement I/O board helps maintain existing cabling and housing fitment while reducing repair time compared with full-board swaps.

Suitable for (tasks / use cases)

• Repairing a laptop with a non-functional front USB port
• Restoring a laptop where the power button no longer responds
• Replacing a damaged internal I/O board after impact or liquid exposure
• Upgrading or refurbishing laptops during maintenance or refurbishment

Key specifications

• Function: Internal I/O module combining USB port and power-button interface
• Form factor: Compact internal board designed for front-panel mounting in compatible HP laptop chassis
• Connectivity: One external USB port integrated on the module
• Interface: Standard motherboard connector and ribbon/plug connection compatible with specified HP laptop internal wiring
• Mounting: Screw and guide-tab alignment points to fit original housing locations

How to use

Power down the laptop, disconnect the battery and any external power source before starting. Open the chassis following the service manual for the specific HP model to access the internal I/O area. Remove the defective module by disconnecting its cable from the motherboard and unscrewing any retaining fasteners. Position the replacement board in the original mounting location, secure it with the appropriate screws, and reconnect the board cable to the motherboard connector. Reassemble the chassis, reconnect the battery and power, then verify USB port detection and power-button operation during system startup.

Recommendations

Handle the board by its edges and avoid contact with exposed circuitry to reduce the risk of electrostatic damage. Use the correct tools and follow the HP service instructions for your laptop model. If uncertain about disassembly or soldering, consider professional repair services to avoid additional damage.