Liimattava varalevy Maclocksin Magnetix-telineeseen Compulocks, musta

This adhesive replacement plate is designed for the Magnetix mount system by Maclocks Compulocks and provides a secure method to attach the mount to flat surfaces without using screws. The black adhesive plate is suitable as a spare or repair part to restore mounting adhesion and maintain device stability when the original adhesive has worn or detached. It is intended for use where a non-permanent, strong bond to smooth surfaces is required.

Advantages

The adhesive replacement plate offers strong adhesion to clean, flat surfaces and is finished in black to match the Magnetix mount aesthetic. It eliminates the need for drilling or screw-fixing, reducing installation time and preserving the mounting surface. As a dedicated spare part for the Magnetix system, it restores original mounting performance and helps maintain device stability during everyday use.

Suitable for

• Attaching Magnetix mounts to flat plastic or metal surfaces
• Replacing worn or degraded adhesive on existing mounts
• Temporary or semi-permanent installations where drilling is not allowed
• Repairing mounts in retail, office, or light commercial environments

Key specifications

• Colour: black
• Compatibility: designed for the Magnetix mount system by Maclocks Compulocks
• Mounting type: adhesive attachment for flat surfaces
• Recommended surface: clean, smooth, non-porous materials such as painted metal, glass or hard plastics

How to use

Clean the target surface thoroughly to remove dust, grease and moisture before applying the adhesive plate. Peel off the protective liner and press the plate firmly onto the surface for the time specified by the adhesive manufacturer to ensure full contact. Allow the adhesive to set as recommended before attaching the Magnetix mount and placing a device on it. If replacing an old plate, remove any residual adhesive and residue prior to installation to ensure optimal bonding.

Recommendations

For best results, apply the adhesive plate at room temperature on a dry, non-porous surface and avoid stressing the bond during the initial curing period. Not recommended for uneven, textured or porous materials; for those surfaces, use screw fixing or alternative mounting solutions.