Maali- ja laastisekoitin EINHELL M14, Ø120×600 mm sekoituskori

Replacement accessory for rotary hammers and paint/mortar mixers from EINHELL, model 49497635. This steel mixer attachment has a total length of 600 mm and a mixing head diameter of 120 mm. Supplied as a single unit, it fits tools with an M14 threaded spindle and is intended for mixing and agitation of liquid construction materials such as paint, varnish, adhesives and thin mortars in containers up to about 80 litres. The robust steel construction is designed to withstand repeated use in workshop and site conditions.

Advantages

The steel construction provides high durability and resistance to bending under load, while the M14 thread ensures a secure connection to compatible mixers. The 600 mm length allows mixing deep in buckets and containers and reduces splash while the 120 mm head offers sufficient flow to homogenise liquids and suspensions. Supplied as a single unit, the accessory is easy to fit and replace when required.

Suitable for

• Mixing paint, varnish and lacquers
• Preparing adhesives, glues and primers
• Stirring thin cement or mortar mixes up to approximately 80 litres
• Use with paint/mortar mixers and rotary hammers that accept M14-threaded attachments

Key specifications

• Material: steel
• Overall length: 600 mm
• Mixing head diameter: 120 mm
• Connection type: M14 threaded
• Supplied quantity: 1 unit
• Intended application: mixing and agitation of liquid or low-viscosity construction materials

How to use

Attach the accessory to a compatible paint/mortar mixer or rotary tool with an M14 threaded spindle. Ensure the connection is tightened securely before starting the tool. Place the mixing head into the container and operate the mixer at a speed appropriate for the material being mixed, avoiding excessive speed that could cause splashing or aeration. Move the mixer steadily through the material to achieve an even consistency, then stop the tool and remove the attachment. Clean the mixer thoroughly after each use to prevent build-up.

Recommendations

Use protective equipment such as gloves and eye protection when mixing. For best results, mix in containers that allow the head to be fully submerged and avoid overfilling. Do not use the accessory with materials or in conditions exceeding the mechanical limits of the tool or the accessory; consult the mixer’s user manual for recommended speeds and load limits. Regularly inspect the steel shaft and thread for wear or damage and replace the accessory if deformation or excessive wear is detected.