Powersplitter-kaapeli ACT AK3195 1x 5,25 inch + 1x 3,5 inch 0,20 m

The ACT Powersplitter cable AK3195 is a short internal power cable designed to supply one 5.25" drive bay device and one 3.5" device from a Molex 4-pin power source. At 0.20 m length, the cable features a single Molex (4-pin) input connector and four additional Molex (4-pin) connectors distributed to the two target devices for straightforward integration inside a PC chassis. It is intended for compact routing and simple power distribution where space is limited.

Advantages

The compact 0.20 m length reduces cable clutter and improves airflow inside small to mid-size cases. Using standard Molex (4-pin) connectors ensures broad compatibility with legacy and common internal devices. The split configuration allows powering both a 5.25" and a 3.5" device from a single source without additional adapters or converters. Construction and connector layout make installation fast and predictable for routine system builds and upgrades.

Suitable for

• Connecting a single 5.25" optical or bay device and a 3.5" drive to a Molex power output
• Compact PC builds where short internal cables are required
• System upgrades that require adding legacy Molex-powered devices
• Organizing power distribution in small form-factor and mid-tower cases

Key specifications

• Cable length: 0.2 m
• Input connector: Molex (4-pin)
• Output connectors: 4 x Molex (4-pin) (providing connections for one 5.25" and one 3.5" device)

How to use

Power off the PC and unplug it from mains before installing the cable. Locate a free Molex (4-pin) power output from the power supply and connect the input Molex connector of the ACT Powersplitter AK3195. Route the short cable to the target bays and attach the Molex outputs to the 5.25" device and the 3.5" device, ensuring correct orientation of each connector. Verify secure, fully seated connections and tidy excess cable to maintain airflow. Restore power and test device operation.

Recommendations

Use this cable for short internal runs; avoid stretching beyond its 0.20 m length. Ensure the combined power draw on the Molex source does not exceed the power supply’s specifications for peripheral connectors. If devices require higher current or modern SATA power, consider using appropriate dedicated cables or adapter solutions.