Virtajohto MicroConnect MC-DUALC14C15-1M — dual IEC C14 - C15, 1 m pituus

MicroConnect MC-DUALC14C15-1M is a dual power cable with a single IEC C14 inlet and two IEC C15 outlets, 1 m in length. It is designed to connect two devices that require IEC C15 inlets to a single C14 power source, commonly used in IT racks and server rooms. The cable provides heat-resistant C15 contacts appropriate for higher-temperature appliance inlets and supports standard mains power distribution in data centers and networking closets.

Advantages

This dual IEC C14 to dual C15 cable allows compact routing and simplified cabling when powering two devices from one C14 source. The C15 outlets are specified for higher-temperature operation up to 120°C, improving safety when used with equipment that presents elevated inlet temperatures. The cable is compatible with common PDUs and offers secure locking at the PDU end to reduce the risk of accidental disconnection, lowering the chance of equipment damage and system downtime. With an electrical rating of 10A / 250V~ and a black finish, the cable fits standard rack and equipment environments.

Suitable for

• Powering servers and rack-mounted equipment with IEC C15 inlets
• Connecting networking devices and switches in data center racks
• Supplying power to PDUs where two outputs are required from one C14 source
• Temporary or permanent cabling in server rooms and telecom closets

Key specifications

• Connector configuration: one IEC C14 inlet to two IEC C15 outlets
• Length: 1 meter
• Electrical rating: 10A / 250V~
• Heat resistance (C15): rated up to 120°C at the connector
• Color: black

How to use

Connect the IEC C14 inlet of the cable to the C14 supply socket on a PDU or other compatible power source, then insert the two IEC C15 outlets into the equipment inlets that require C15 connectors. Ensure connectors are fully seated and that the PDU end locks securely where a locking PDU is present. Verify the combined current draw of the two devices does not exceed the 10A rating of the cable and that the upstream circuit and PDU are rated to handle the load.

Recommendations

Before installation, confirm device inlet type (C15) and total current consumption. Avoid routing the cable near sharp edges or heat sources beyond standard equipment operating temperatures. Use this cable within its electrical rating and replace it if damage or wear to the insulation or connectors is observed.