ACT DA6930 Cat6a U/FTP (STP) -verkkokaapeli 0,15 m, RJ-45–RJ-45, kullatut kontaktit, musta

ACT DA6930 is a 0.15 m Cat6a U/FTP (STP) slimline patch cable with RJ-45 connectors on both ends. The cable has a reduced outer diameter of 3.8 mm and a smaller bend radius compared with standard Cat6a cords, which helps improve airflow in server racks and network cabinets. Both RJ45 plugs are 90° angled up, making the cable suitable for tight spaces behind equipment and inside cabinets. The jacket is LSZH (Low Smoke Zero Halogen) to lower the risk of toxic gas release in case of fire or damage. The cable uses full copper 32 AWG conductors and 50 µ gold-plated RJ45 contacts and meets relevant international standards.

Advantages

The slim 3.8 mm diameter and reduced bend radius provide better cable management and improved airflow in dense rack installations. Angled-up RJ45 connectors allow secure connections where vertical clearance is limited. LSZH jacket increases safety in enclosed spaces, while full copper conductors and gold-plated contacts ensure reliable signal transmission and corrosion resistance. Cables are factory tested to verify performance.

Suitable for

When it may not be suitable

This 0.15 m cable is intended for very short patch connections; it is not suitable for long-distance runs or permanent horizontal cabling. Environments that require a different connector orientation (straight, 90° down, left or right) should choose the appropriate version rather than this angled-up to angled-up variant.

Key specifications

How to use

Connect one 90° angled RJ45 plug to the network port on your switch, patch panel or device and the other angled plug to the corresponding port. Route the slimline cable along rack paths or cable management channels to preserve airflow and avoid tight kinks. Ensure the angled orientation matches the available clearance before installation.

What to consider before purchase

Recommendations

Use this slimline Cat6a U/FTP patch cable for short connections in dense rack environments where improved airflow and reduced bend radius are required. Choose the correct connector orientation and avoid stretching or bending beyond the cable's natural curve to maintain performance.