ACT virtajohto CEE 7/7 pistoke (kulma) - C13 keltainen 3 m

The ACT Power cord CEE 7/7 male angled AK5143 is a 3 m yellow power cable with an angled CEE 7/7 male plug and an IEC C13 coupler designed for 230 V mains. Its length and angled plug make it suitable for connecting computers, network equipment and other IEC C13 appliances in locations with limited space behind cabinets or racks. The visible yellow jacket allows easy identification of power runs and helps separate circuits or mark specific device groups.

Advantages

The cable combines a space-saving angled CEE 7/7 male connector with a standard C13 coupler, providing compatibility with a wide range of equipment that accepts IEC C13 inlets. A 3 m length offers flexibility for routing while maintaining a secure connection. The yellow outer jacket improves visibility for cable management and safety. The design follows common safety and performance expectations for mains power cords used with 230 V devices.

Suitable for

• Connecting desktop PCs, monitors and workstations to 230 V power sockets where rear access is limited
• Powering servers, switches and UPS units with IEC C13 inlets in small server racks or cabinets
• Temporary or permanent installations where colored cabling is used for circuit identification

Key specifications

• Cable length: 3 m
• Input connector: angled CEE 7/7 male plug for 230 V mains
• Output connector: IEC 60320 C13 coupler
• Color: yellow outer jacket
• Typical use: mains power cord for IEC C13-equipped devices

How to use

Insert the angled CEE 7/7 male plug into a compatible 230 V wall outlet or power strip, taking care to orient the angled plug so it fits the available clearance. Connect the IEC C13 coupler to the device’s IEC C14 inlet until it seats securely. Route the cable to avoid sharp bends, kinks or contact with heat sources. Verify that the connected device is switched off before making the connection if required by the device manufacturer.

Recommendations

For safe operation, use the cable only with devices rated for 230 V and with matching IEC C13 inlets. Avoid overloading the power source; check the device and outlet ratings. Inspect the cable periodically for wear, cuts or damage to the outer jacket and replace the cord if any damage is found. Use the yellow color to mark and manage power circuits in multi-cable installations.