Virtakaapeli ACT Powercord italialainen uros - C13 musta 2,5 m

The ACT Powercord Italian plug - C13 black 2.5 m is a mains power cable designed for connecting electronic equipment to Italian type L sockets. With a 2.5 m length and a C13 coupler, the cable provides a balance of reach and compactness for desktop computers, monitors, printers and similar devices. It is rated for 230 V and 10 A, and features a black outer sheath for a discreet appearance and resistant handling in office and home environments.

Advantages

The cable combines a standardized C13 coupler and an Italian type L plug to ensure compatibility with a wide range of power supplies and IEC-equipped devices. Its 2.5 m length gives additional flexibility for placement of equipment relative to wall outlets. The construction is intended for routine use with a rating of 230 V and 10 A, and the black colour helps the cable blend with typical office or AV setups.

Suitable for

• Connecting desktop PCs and workstations to Italian type L wall outlets
• Powering monitors, network devices and small servers with C13 inlets
• Home office and office environments requiring a mid-length mains cable
• Replacing worn or lost power leads for compatible equipment

Key specifications

• Cable length: 2.5 m
• Connector 1: Power plug type L (Italian)
• Connector 2: C13 coupler (IEC 60320 C13 compatible)
• Rated voltage: 230 V
• Rated current: 10 A
• Colour: Black

How to use

Inspect the cable and connectors for visible damage before use. Insert the Italian type L plug into a suitable mains socket firmly and connect the C13 coupler to the device's IEC C14 inlet until it seats securely. Ensure the cable is routed to avoid trip hazards and not bent sharply near the connectors. Disconnect by pulling the plug rather than the cable when removing from a socket.

Recommendations

Use the cable indoors and within the specified 230 V/10 A rating. Do not use with devices that exceed the listed current rating or in environments with excessive moisture or heat. For permanent or critical installations, verify connector compatibility and condition periodically and replace the cable if any wear, cracking or connector looseness is detected.