ACT virtakaapeli C14 – C15 (kulma oikea) IEC60320 musta 0,6 m

ACT power cord with IEC60320 C14 inlet to an angled-right C15 outlet, 0.6 m long. The flexible H05RN-F cable is rated for 10 A and 250 V and is designed to connect servers, UPS units, power distribution units and other IT equipment. The angled C15 termination helps routing in tight rack spaces while the C15 connector is high-temperature resistant up to 120°C.

Advantages

The short 0.6 m length and angled C15 connector minimise cable clutter and improve routing in dense racks. H05RN-F construction provides flexibility and durability for typical data centre and office environments. The C15 outlet is rated for higher temperatures, making it suitable for equipment that may produce increased heat at inlet points.

Suitable for

When it may not be suitable

This cable is relatively short at 0.6 m and intended for close-proximity connections inside racks or between adjacent devices; it is not suitable when longer reach is required. It also uses an IEC C15 outlet and therefore is only compatible with equipment that accepts C15 inlets.

Key specifications

How to use

Insert the IEC C14 male end into the equipment or PDU inlet and plug the angled C15 female end into the device with a C15 inlet. Route the cable through the rack to utilise the angled termination for neat cable management and to reduce strain at connector points. Ensure the power is turned off on devices before connecting or disconnecting the power cord.

What to consider before purchase

Recommendations

Use this short, angled C14–C15 power cord for close-proximity rack connections where heat-resistant C15 inlets are required. Avoid excessive bending near the connectors and inspect the cable periodically for wear.