Ajoneuvon akkulaturi AZO Ansmann 1001-0143 6–12 V, 2 A, Type-C-pistoke

The AZO Ansmann 1001-0143 wired vehicle battery charger is designed for charging 6 V and 12 V lead-acid batteries used in small vehicles and equipment. With a nominal output current of 2 A and a Type C (Europlug) mains connector, this compact charger provides steady charging suitable for routine battery maintenance, trickle charging and occasional replenishment of small-capacity automotive batteries. The unit is supplied as a single charger ready for in-garage or workshop use.

Advantages

This charger delivers a constant 2 A output current appropriate for slow and controlled charging of lead-acid battery types. Its compatibility with both 6 V and 12 V systems makes it versatile for a range of small vehicles and equipment. The Type C mains plug ensures easy connection to standard European sockets, while the compact wired design supports convenient placement and storage in a garage or service area. The device is intended for maintenance charging and top-ups rather than rapid high-current jump-starting.

Suitable for

• Maintenance and trickle charging of 6 V lead-acid batteries
• Maintenance and trickle charging of 12 V lead-acid batteries
• Small cars, scooters, motorcycles and garden equipment
• Garage and workshop battery upkeep and seasonal storage

Key specifications

• Output voltage: selectable for 6 V or 12 V lead-acid batteries
• Output current: 2 A (steady)
• Input connector: Type C (Europlug) mains plug
• Battery chemistry supported: lead-acid (including flooded, sealed and conventional types where applicable)
• Intended use: maintenance charging, trickle charging and regular top-ups

How to use

Before connecting, confirm the battery voltage (6 V or 12 V) and ensure the vehicle or equipment is switched off. Plug the charger into a compatible Type C mains outlet, then connect the charger's output leads to the battery terminals observing correct polarity. Start charging according to the charger's indicator signals or lamp if present; allow the charger to run until the battery reaches the required charge level for storage or use. Disconnect the charger from the mains before removing the clamps from the battery terminals.

Recommendations

Use the charger primarily for regular maintenance, slow charging and keeping batteries at safe storage charge levels. Avoid using the unit as a primary device for rapid recharging or jump-starting high-capacity automotive batteries. Observe standard safety precautions: work in a well-ventilated area, avoid sparks near the battery, and follow battery manufacturer guidelines when charging.