Aktiivinen optinen kaapeli CBO SFP28 AOC BlueOptics BO272703Q20M 20 m

Active Optical Cable CBO SFP28 BlueOptics BO272703Q20M 20 m is a factory-terminated SFP28 form-factor fiber-optic direct-attach solution engineered for 25 Gbps links. The single-unit cable integrates optical transceivers and fiber in a single assembly to provide a plug-and-play connection between switches, servers and storage devices. With a 20 m length, this BlueOptics AOC is intended for short- to mid-range data center connections where low latency, immunity to electromagnetic interference and simplified cabling are required.

Advantages

This AOC delivers 25 Gbps data throughput with reduced power consumption compared with separate transceiver plus fiber assemblies thanks to integrated optics. The pre-terminated SFP28 housings remove the need for field termination or patch cords, enabling faster deployment and consistent optical performance. Being an optical link, it avoids electromagnetic interference and cross-talk common in copper interconnects, while providing low latency and stable signal integrity over the 20 m span.

Suitable for

• High-speed uplinks between Top-of-Rack or Leaf switches and aggregation or spine switches
• Server-to-switch interconnects in dense rack environments
• Interconnections between storage arrays and compute nodes requiring 25 Gbps bandwidth
• Data center layouts where predictable optical performance and EMI immunity are important

Key specifications

• Form factor: SFP28 direct-attach active optical cable
• Nominal data rate: 25 Gigabits per second
• Length: 20 meters
• Connector type: SFP28 compatible plugs on both ends
• Cable medium: integrated optical fiber with active transceiver modules
• Typical use: short- to mid-range data center links

How to use

Install the AOC by inserting each SFP28 connector into the corresponding SFP28 ports on network equipment until it latches. Ensure ports are powered down or follow hot-plug guidance from your equipment vendor if required. The link will negotiate at 25 Gbps if both endpoints support that speed; verify link status and interface counters on the devices after installation. There is no field termination or polishing required—handle the cable and connectors by the housings and avoid bending the cable beyond recommended bend radius to maintain optical performance.

Recommendations

Use this 20 m BlueOptics AOC for in-row or across-rack connections inside data centers where a standardized SFP28 interface is supported. Avoid exposure to moisture and keep connectors capped when not in use. Confirm compatibility with switch and server vendor SFP28 listings before deployment, and route the cable to prevent sharp bends or mechanical stress.