Asennussarja DELOCK 86762, punainen muovi, malli 86762, muovimateriaali

DELOCK 86762 mounting kit is a red plastic accessory designed to hold a single Keystone module in cases and enclosures. Manufactured from plastic, the kit provides a lightweight, non-conductive mounting solution with standardized dimensions that allow easy snap-in installation of one Keystone module. The red colour makes the component easy to identify during assembly and maintenance.

Advantages

The mounting kit offers a compact, lightweight form factor and is made of plastic to provide electrical insulation where conductive parts would be unsuitable. Standardized dimensions simplify installation in a variety of housings, enabling a secure snap-in fit for a Keystone module without additional fasteners. The red finish improves visual identification during routing and service.

Suitable for

• Mounting a single Keystone module in electronic enclosures
• Cases and panels requiring a non-conductive holder
• Cable routing and organization where a snap-in module is needed
• Lightweight equipment assembly where metal fasteners are to be avoided

Key specifications

• Material: plastic
• Colour: red
• Designed for: one Keystone module (standardized dimensions)
• Mounting type: snap-in for cases and enclosures
• Function: non-conductive holder for modular connection components

How to use

Insert the DELOCK 86762 mounting kit into the corresponding opening in the case or enclosure following the enclosures standardized cutout dimensions. Press the holder into place until the snap-in retention engages, then insert the Keystone module into the holder until it locks. No additional screws or tools are typically required; ensure the module is seated correctly and that the holder is fully engaged with the enclosure to prevent movement during use.

Recommendations

Use this plastic mounting kit in applications where electrical insulation and lightweight construction are priorities. Verify that the enclosure cutout matches the Keystone holders standardized dimensions before installation. Avoid exposing the plastic parts to prolonged high temperatures or direct flames to preserve mechanical integrity.