BlueOptics 100G-QSFP-QSFP-AOC-1501-BO InfiniBand-kuituoptinen kaapeli 15 m QSFP28 uros/uros

The BlueOptics 100G-QSFP-QSFP-AOC-1501-BO is a 15 m active optical cable (AOC) with QSFP28 male connectors on both ends, designed for InfiniBand and 100G networking environments. It supports high-speed data transmission over multimode fiber and is built to the QSFP28 MSA interface standard for electrical, mechanical and functional compatibility with equipment that accepts QSFP28 AOCs. The cable integrates transceivers at both ends for optical signal transmission and includes digital diagnostics monitoring (DDM/DOM) capability to report operational parameters in real time.

Advantages

This 15 m QSFP28 AOC provides a factory-assembled fiber connection that reduces the need for panel patching and manual connector cleaning. Its construction follows MSA specifications for interoperability and is tested for compatibility with major hardware platforms that support QSFP28 AOCs. The integrated DDM/DOM function enables remote monitoring of supply voltage, optical transmit/receive power, laser bias current and temperature. The cable is suitable for environments where immunity to electromagnetic interference and minimal latency are required.

Suitable for

• Data center top-of-rack and leaf-spine connections
• High-performance computing (HPC) clusters and InfiniBand interconnects
• Switch-to-switch and switch-to-storage links at up to 100 Gbps
• Short-reach multimode fiber connections inside racks or between adjacent racks

Key specifications

• Length: 15 meters
• Connector type: QSFP28 male to QSFP28 male
• Rated data rate: up to 100 Gbps
• Media type: multimode fiber (AOC)
• Interface standard: QSFP28 MSA compliant
• Digital diagnostics: DDM/DOM support for real-time monitoring

How to use

Install the BlueOptics QSFP28 AOC by inserting each QSFP28 connector into the corresponding QSFP28 port on your devices until the latch engages. Verify that the host hardware supports QSFP28 AOCs and, where applicable, DDM/DOM functionality to access diagnostic data. The pre-assembled AOC eliminates the need for separate transceiver modules and patch cords; route the cable to prevent tight bends and avoid mechanical strain on the connectors. Power cycle is generally not required, but consult your equipment vendor's instructions if link negotiation does not establish automatically.

Recommendations

Ensure device compatibility with QSFP28 AOCs before deployment. Use proper cable management to maintain the specified bend radius for multimode fiber and keep connector interfaces free of dust. If DDM/DOM data is required, confirm that the host system exposes diagnostic parameters. For critical links, consider obtaining a sample for verification in your environment prior to large-scale deployment.