BlueOptics 1783-SFP1GLX-BO kuitu-lähetin-vastaanotinmoduuli SFP 10000 m

The BlueOptics 1783-SFP1GLX-BO is a single-mode fiber SFP transceiver module designed for high-speed optical links up to 10,000 m. The module uses an SFP interface in an aluminium housing and weighs approximately 20 g, making it compact and suitable for use in a variety of network devices that accept standard SFP modules. It implements 1000BASE-LX transmission characteristics with LC duplex connectivity and is intended for reliable long-distance Ethernet, Fibre Channel over Ethernet or SDH/SONET links at up to 1.25 Gbit/s.

Advantages

The transceiver follows MSA-compliant SFP form-factor and LC duplex connector standards, enabling broad compatibility with switches, routers, storage systems and other equipment that support standard 1000BASE-LX SFP modules. An aluminium housing provides mechanical protection and thermal stability while the lightweight design facilitates installation in dense rack environments. The module supports single-mode fiber transmission at 1310 nm for both transmitter and receiver channels, delivering long-reach connectivity without susceptibility to electromagnetic interference.

Suitable for

• Long-distance Ethernet links up to 10 km
• Interconnecting switches and routers across buildings or campuses
• Storage area network (FCoE) links and high-speed uplinks
• SDH/SONET and other optical backhaul applications

Key specifications

• Interface type: SFP (MSA-compliant)
• Transmission standard: 1000BASE-LX (1.25 Gbit/s)
• Fiber type: Single-mode fiber
• Wavelength: 1310 nm (TX and RX)
• Connector: LC duplex
• Maximum reach: up to 10,000 m
• Housing material: aluminium
• Weight: approx. 0.02 kg

How to use

Install the BlueOptics SFP module into an empty SFP port of compatible network equipment until it latches securely. Connect LC duplex single-mode fiber patch cords with correct polarity to the module and to the remote transceiver or patch panel. Ensure the connected device is configured for 1000BASE-LX operation and that any required auto-negotiation or link settings are enabled on the host hardware. If the host supports digital diagnostics (DDM/DOM), monitor the transceiver parameters through the management interface as needed.

Recommendations

Use quality single-mode LC duplex patch cords and clean connectors to preserve signal integrity. Verify that the host hardware supports DDM/DOM if you rely on remote diagnostic readings. Avoid bending fiber beyond manufacturer-specified minimum bend radii and follow ESD precautions when handling the module.