AOC CBO Fortinet QSFP-100G-AOC-5M aktiivinen optinen kaapeli 100G, 5 m

The AOC CBO Fortinet QSFP-100G-AOC-5M active optical cable provides a fixed 5 metre duplex optical link for 100 Gbit/s connections between QSFP-enabled network devices. Designed for high-speed interconnects in data centres and enterprise networks, this AOC supports reliable transmission with low latency and reduced susceptibility to electromagnetic interference compared with copper alternatives. The cable is intended for short-reach connections where a QSFP transceiver-style direct attach is required but optical performance and simplified cabling are preferred.

Advantages

This active optical cable delivers 100 Gbit/s full-duplex throughput over a compact, pre-terminated 5 m assembly, eliminating the need for separate transceivers and patch cords. The optical construction reduces signal degradation over the specified distance and reduces interference from nearby electrical equipment. The plug-and-play form factor supports straightforward installation and swap-out in QSFP ports, while the fixed-length design helps maintain consistent link performance and simplifies cable management in dense rack environments.

Suitable for

• High-speed interconnects between switches and routers in data centres
• Direct server-to-switch or server-to-server 100G connections
• Top-of-rack and end-of-row short-reach links
• Environments requiring low-latency, EMI-resistant cabling

Key specifications

• Data rate: 100 Gbit/s full duplex
• Connector / form factor: QSFP-compatible plug-in AOC
• Link length: 5 metres fixed duplex optical cable
• Medium: active optical cable (multimode optical link with active electronics)
• Typical applications: short-reach interconnects within racks and across adjacent racks

How to use

Insert each QSFP connector into the corresponding QSFP port on your network devices until the module latches. Confirm link status through device LEDs or management interfaces according to the host equipment documentation. No additional transceivers or patch cables are required; the cable is supplied as a single pre-terminated assembly. For replacement, power down or follow hot-swap procedures recommended by your equipment vendor before removing the existing cable if required by the hardware.

Recommendations

Route the cable to avoid sharp bends and mechanical strain; maintain the manufacturer’s minimum bend radius. Use cable management trays or ties to secure the assembly and avoid excessive tension on the connectors. Verify device compatibility with QSFP-AOC modules in your switches or servers and ensure firmware or driver updates are applied as recommended by the equipment vendor for optimal interoperability.