AOC CBO PAN-QSFP-AOC-20M 20 m QSFP Active Optical -kaapeli QSFP-porteille

AOC CBO PAN-QSFP-AOC-20M 20 m QSFP Active Optical Cable for QSFP ports is a factory-terminated, 20‑metre active optical interconnect for connecting QSFP ports directly without separate transceivers. Designed for high-speed network links in data centers, switches and routers, the cable delivers optical signal transmission over 20 metres while reducing cabling complexity and power consumption compared with equivalent copper assemblies. The plug-and-play design supports direct connection of QSFP-capable equipment and simplifies link deployment where moderate reach and high throughput are required.

Advantages

The active optical cable eliminates the need for separate QSFP transceivers and associated modules, providing a single-cable optical solution that reduces heat and power draw at the host ports. At 20 m length it enables flexible placement of network equipment across racks or aisles while maintaining low-latency, high-throughput connectivity. Factory-terminated optical fibers and QSFP-compatible connectors ensure consistent performance and easier installation than field-terminated fiber assemblies.

Suitable for

• Short-reach interconnects between QSFP ports in data center racks
• Direct links between switches, routers and high-performance servers
• High-throughput connections where 20 m optical reach is sufficient
• Environments that benefit from reduced power and simplified cabling versus copper

Key specifications

• Cable type: Active Optical Cable (AOC)
• Connector interface: QSFP-compatible plug for QSFP ports
• Length: 20 metres
• Application: High-speed optical interconnect for QSFP ports in data centers and networking equipment
• Design: Factory-terminated, plug-and-play optical link without separate transceivers

How to use

Install the cable by inserting each QSFP-compatible end into the corresponding QSFP port on the devices to be connected. Ensure ports are QSFP-compatible and powered off or follow hot-plug procedures recommended by the equipment vendor. No separate transceivers or fiber terminations are required; the cable is ready for immediate use after proper insertion and link negotiation between devices. Verify link status via the host equipment management interfaces and confirm required data rates and lane configurations are negotiated correctly.

Recommendations

Use this 20 m QSFP AOC for intra-rack or adjacent-rack links where optical reach replaces copper for lower power and simpler cable management. Avoid tight bends, excessive pulling tension and exposure to harsh mechanical stress; follow standard cable handling practices and vendor guidance for QSFP port hot-plugging and compatibility.