BlueOptics AOC Meraki SFP-AOC-10G-3M 10G aktiivinen optinen kaapeli 3 m

BlueOptics AOC Meraki SFP-AOC-10G-3M 10G Active Optical Cable 3 m is a pre-terminated SFP+ active optical cable designed for short-range, high-speed connections between network switches, servers and storage devices. The 3‑metre multimode optical link delivers a 10 Gbps data rate in a compact plug‑and‑play SFP+ form factor. The AOC reduces cabling complexity and thermal load compared with equivalent copper SFP+ direct-attach cables, making it suitable for dense network racks and data centre topologies.

Advantages

The cable provides a reliable 10 Gbps throughput over a 3 m multimode optical channel while maintaining compatibility with SFP+ ports. Its active optical design enables lower power dissipation and reduced electromagnetic interference versus copper alternatives. The pre-terminated SFP+ connectors simplify installation with plug-and-play operation, and the flexible jacket supports routing in confined rack spaces. The sealed optical interfaces reduce the need for field termination and minimize maintenance.

Suitable for

• Short-reach 10 GbE uplinks between switches in data centres and server rooms
• Direct connections between servers and top-of-rack switches
• High-density rack deployments where reduced heat and cable bulk are desired
• Storage area network links requiring low-latency 10 Gbps connectivity

Key specifications

• Form factor: SFP+ (active optical cable)
• Nominal data rate: 10 Gbps
• Length: 3 metres
• Fiber type: multimode optical link suitable for short-range connections
• Connector: SFP+ pre-terminated plug-and-play
• Power and thermal: lower power dissipation compared with copper direct-attach cables
• Cable jacket: flexible for rack routing and cable management

How to use

Insert each SFP+ connector into the corresponding SFP+ port on the network devices until it latches. Ensure devices are powered and configured for 10 GbE operation; the cable is plug-and-play and normally recognised by switches and servers without additional configuration. Route the cable through rack management channels to avoid sharp bends and secure it to prevent mechanical stress on the connectors. For best signal integrity, keep the length within the specified 3 m range and avoid tight loops or crushing.

Recommendations

Verify compatibility with the target device SFP+ port and firmware policy before deployment. Use the cable in indoor rack or data-centre environments away from sources of physical damage and avoid exposure to liquids or excessive temperatures. Inspect connectors for contamination and clean with appropriate optical cleaning tools if required prior to insertion.