CBO QSFP optinen moduuli JQP-04LMBA2 25G

The CBO QSFP optical module JQP-04LMBA2 25G provides a single-channel 25 Gigabit interface for high-speed data transmission in compatible QSFP ports. Designed for use in data center switches, routers and network appliances, the module enables a straightforward upgrade or replacement of optical links to increase throughput and maintain reliable connectivity. The transceiver supports standard electrical and optical interfaces for 25G connections and is intended for use with compatible networking equipment that accepts QSFP-format optical modules.

Advantages

This BlueOptics QSFP module offers compact QSFP form-factor compatibility with common network devices, allowing simple hot-swap replacement without modifying existing hardware racks. The 25G single-channel design delivers higher per-lane bandwidth compared to lower-rate modules while maintaining low power consumption and stable optical performance. Built to industry-compatible specifications, the module facilitates predictable link behavior and easier inventory management when standardizing on 25G optics.

Suitable for

Key specifications

How to use

Install the module by inserting it into a compatible QSFP port until it seats securely; follow your switch or router documentation for hot-swap procedures and link configuration. Configure the host device for a 25G interface as required by the operating system or network firmware, and verify link status and data rate through device management tools. When removing the module, power down or follow the vendor-recommended hot-swap steps to avoid link flapping or device errors.

Recommendations

Use certified cables and ensure transceiver and host compatibility before deployment. For stable performance, operate within recommended temperature ranges and monitor optical power and link status after installation. If interoperability issues occur, check firmware versions on both the module host and connected devices and consult vendor compatibility lists.