CBO SFP28 passiivinen Direct Attach -kuparikaapeli 1 m (BlueLAN SFP28-DAC-1M)

CBO SFP28 Passive Direct Attach Copper Cable 1m (BlueLAN SFP28-DAC-1M) is a factory-terminated, twin-ax copper twinaxial cable designed for short-reach 25GbE connections between SFP28 ports. The cable provides a direct electrical link without optical transceivers, enabling compact, low-latency interconnects for switches, network interface cards (NICs) and servers in data center topologies and rack-to-rack cabling. The 1 metre length is intended for close-proximity connections in equipment racks and server enclosures, and the robust construction supports reliable signal integrity for 25 Gbit/s links.

Advantages

This passive SFP28 DAC requires no external power or optical modules, which reduces component count and simplifies installation. The direct copper connection delivers low latency and consistent performance at 25Gbps while remaining cost-effective compared with active optical solutions for short distances. The cable assembly is pre-terminated for plug-and-play use with compatible SFP28 ports and is suitable for environments where space is limited and predictable electrical characteristics are needed.

Suitable for

• Short-reach 25 Gigabit Ethernet connections between switches
• Server-to-switch or NIC-to-switch links within racks
• High-density data centre top-of-rack and middle-of-row cabling
• Applications requiring low-latency, short-distance interconnects

Key specifications

• Interface type: SFP28 to SFP28 direct-attach twinax copper
• Nominal data rate: 25 Gbit/s
• Length: 1 metre
• Cable type: Passive twinax copper assembly
• Connector form factor: SFP28 compatible plug
• Typical use: Short-reach rack or chassis interconnects

How to use

Insert each SFP28 plug into the SFP28 port on the two devices to be connected, ensuring the latch engages and the connector is fully seated. No transceiver configuration is required on the cable itself; configure network settings on the connected devices as needed for link negotiation at 25GbE. For best results, route the cable to avoid sharp bends and mechanical strain and confirm link status via the device LEDs or management interface.

Recommendations

Use this passive 1m SFP28 DAC for short, direct connections inside racks or between adjacent racks. Avoid exceeding the recommended bend radius and keep the cable away from high-electromagnetic-noise sources. Verify compatibility with the SFP28 ports on your switches and servers before deployment and follow equipment vendor guidance for firmware and supported cable assemblies.