Kuitulähetin-vastaanotin CBO AFBR-89CEDZ-BC-BO QSFP28 100000 Mbit/s

The BlueOptics CBO AFBR-89CEDZ-BC-BO QSFP28 is a fiber optic transceiver designed for 100 Gbps network links. It implements the QSFP28 compact form factor suitable for installation in servers, switches and data center interconnects. The module supports a 100000 Mbit/s data rate over optical fiber, enabling high-throughput point-to-point connections and uplinks in high-density networking environments.

Advantages

This QSFP28 transceiver offers a compact, hot-pluggable solution for upgrading or expanding 100 Gbps optical connections. Its compliance with standard QSFP28 interfaces ensures broad compatibility with modern switches and routers. The module is engineered for reliable long-term operation in data center and carrier-class networks, providing stable throughput and consistent optical performance.

Suitable for

• 100 Gbps server-to-switch or switch-to-switch links
• Data center spine-and-leaf interconnects
• High-bandwidth aggregation and uplink interfaces
• Upgrading existing optical ports to 100 Gbps

Key specifications

• Form factor: QSFP28
• Nominal data rate: 100000 Mbit/s (100 Gbps)
• Transmission medium: optical fiber
• Interface: QSFP28 electrical/optical
• Compatible applications: server, switch and data center interconnects

How to use

Install the transceiver into a compatible QSFP28 port on the switch, router or server while the host device is powered on, using the hot-pluggable capability. Connect the appropriate fiber optic cable to the module according to the link type (single-mode or multi-mode) supported by both ends. Verify link status through the host device management interface and monitor optical parameters where available to confirm correct operation.

Recommendations

Use certified single-mode or multi-mode fiber and matched patch cords for optimal signal integrity. Ensure that both ends of the optical link use compatible QSFP28 transceivers and that device firmware and port configurations support 100 Gbps operation. Follow standard ESD precautions when handling the module and keep connector dust caps in place until cabling is attached.