KuitusFP+-lähetin-vastaanotin CBO 407-BBZM-BO 10000 Mbit/s LC

CBO 407-BBZM-BO is a fiber optic SFP+ transceiver that supports a 10000 Mbit/s data rate and uses an LC connector. It is designed for high-speed uplink and server connections, delivering optical transmission over single-mode or multimode fiber (as specified by the installed module variant) for network equipment with SFP+ slots. The module supports hot-plug installation and is intended for use in switches, routers and servers where a compact 10 Gb/s fiber interface is required.

Advantages

The transceiver provides a standardized SFP+ form factor for easy compatibility with devices that accept pluggable modules. With support for 10 Gbit/s links and an LC connector it enables straightforward integration into existing fiber infrastructures. Hot-pluggable design reduces downtime during upgrades or replacements, while the optical interface ensures low-latency, high-bandwidth connections suitable for uplinks and server interconnects.

Suitable for

• 10 Gb/s uplink ports on enterprise switches and routers
• Server-to-switch fiber connections in data centers
• Aggregation links and inter-switch trunks
• Network equipment with SFP+ cages requiring LC optical modules

Key specifications

• Data rate: 10000 Mbit/s (10 Gb/s)
• Connector type: LC duplex
• Form factor: SFP+ (small form-factor pluggable plus)
• Optical transmission: 10 Gigabit Ethernet over fiber
• Hot-pluggable: yes

How to use

Install the transceiver into an available SFP+ slot on compatible network equipment until it clicks into place. Connect LC fiber patch cords to the module, observing transmit/receive orientation. After insertion, configure the device port as required in the switch or server operating system or management interface. For replacement, remove the module while the port is disabled or follow the equipment vendor’s hot-swap guidance to avoid traffic disruption.

Recommendations

Verify fiber type and link budget compatibility between endpoints before deployment. Use high-quality LC patch cords and keep fiber connectors clean to maintain expected signal performance. Observe electrostatic discharge precautions during handling and consult the network equipment documentation for supported optical module types and firmware compatibility.