BlueOptics QSFP-AOC-15M-CP-BO InfiniBand-kuitu kaapeli 15 m uros/uros

The BlueOptics QSFP-AOC-15M-CP-BO InfiniBand fibre optic cable 15m Male/Male is a 15-metre active optical cable designed for high-bandwidth, low-latency connections between QSFP-equipped devices. With QSFP connectors on both ends and a male-to-male configuration, this cable supports high-speed data transmission in data centers and high-performance computing setups where reliable short to medium reach links are required. The cable’s construction minimises signal degradation while maintaining electrical isolation and reduced electromagnetic interference compared with copper alternatives.

Advantages

This BlueOptics AOC provides high throughput with low latency suitable for InfiniBand fabrics and other QSFP-based interconnects. The optical design offers immunity to electromagnetic interference and improves heat and power characteristics versus equivalent copper solutions. A 15-metre length offers flexible routing between racks or within larger cabinets while preserving signal integrity. The male-to-male QSFP terminations ensure straightforward plug-and-play installation with compatible QSFP ports.

Suitable for

• Interconnects between switches, servers and storage systems in data centres
• High-performance computing clusters using InfiniBand fabrics
• Short- to medium-reach links within rack groups or between adjacent racks
• Upgrading existing QSFP-enabled equipment to optical active cabling

Key specifications

• Connector type: QSFP male to QSFP male
• Cable type: Active optical cable (AOC)
• Length: 15 metres
• Application: InfiniBand and QSFP-based high-speed interconnects
• Signal medium: Multi-mode optical transmission for short-to-medium reach
• Latency: Low-latency design suitable for high-performance computing

How to use

Install the BlueOptics QSFP-AOC-15M-CP-BO by aligning each QSFP male connector with the corresponding QSFP port on your devices and gently inserting until the connector seats and any retention mechanism engages. Ensure both endpoints are powered down or that hot-swap procedures for your equipment are followed if supported. Verify link status through the host devices or switches after connection. Route the cable to avoid sharp bends and excessive tension; use cable management within racks to maintain the minimum bend radius specified by the equipment manufacturer.

Recommendations

For optimal performance, use this AOC in environments with compatible QSFP ports and follow equipment vendor guidance for supported InfiniBand speeds and link configurations. Avoid running the cable alongside high-power electrical lines and maintain recommended bend radii to prevent signal loss or mechanical damage.