SFP+ aktiivinen optinen kaapeli CBO Alcatel-Lucent SFP-AOC-10G-7M 10Gbps 7 m

The SFP+ Active Optical Cable CBO Alcatel‑Lucent SFP-AOC-10G-7M 10Gbps 7m is a factory-assembled optical link designed for direct attachment between compatible SFP+ ports. It delivers a 10 Gbps full-duplex connection over a 7-meter OM-rated optical cable, integrating transceiver electronics and fiber in a single pluggable assembly. The cable is intended to simplify high-speed server, switch and storage interconnects by reducing the number of separate components and the bulk of traditional fiber patching.

Advantages

This active optical cable provides a low-latency 10Gbps connection while eliminating the need for separate transceivers and fiber patch cords. Its integrated design reduces rack clutter and simplifies installation and cable management. The plug-and-play SFP+ form factor supports hot-plug operation in compatible ports and helps maintain consistent optical performance across the full 7 m link length.

Suitable for

• Direct server-to-switch connections in data centers
• Switch-to-switch uplinks where 10Gbps throughput is required
• High-performance storage area network links and SAN aggregation
• Short-reach interconnects inside racks and between adjacent racks

Key specifications

• Data rate: 10 Gbps full duplex
• Length: 7 meters optical link
• Connector type: SFP+ pluggable ends
• Optical type: Active optical cable with multimode OM fiber
• Latency: low-latency active optical design suitable for high-throughput applications
• Power: powered via SFP+ host interface (no external power supply)
• Operating environment: designed for typical data center ambient conditions

How to use

Ensure both devices have compatible SFP+ ports supporting active optical cables. With equipment powered on or in hot-plug capable ports, insert each SFP+ end into the corresponding port until it latches. Verify link status via the host device LEDs or management interface and confirm negotiated 10Gbps operation. For removal, release the latch and withdraw the connector carefully by the housing to avoid stress on the cable and transceiver modules.

Recommendations

Route the cable to avoid sharp bends and mechanical strain, maintaining the manufacturer’s minimum bend radius for optical fibers. Use appropriate cable management to prevent excessive tension and to preserve optical performance. Verify compatibility with the equipment vendor’s supported SFP+ AOC list where required and handle connectors with care to avoid contamination.