SFP+ lähetin-vastaanotin-moduuli CBO AA1403017-E6-BO 10 Gbit/s 1310 nm

CBO AA1403017-E6-BO is an SFP+ transceiver module that supports 10 Gbit/s data transfer at a 1310 nm wavelength. The module is intended for optical fiber links in Ethernet networks and data center environments. Its compact SFP+ form factor provides hot-pluggable installation and compatibility with standard 10GbE ports, enabling short- to medium-range optical connections for network upgrades and server interconnects.

Advantages

The BlueOptics SFP+ module offers a consistent 10 Gbit/s throughput and uses a 1310 nm wavelength optimized for single-mode fiber links over short to medium distances. Hot-pluggable design allows replacement or addition without powering down equipment. The compact SFP+ format conserves port density in switches and servers while remaining compatible with common 10GbE interfaces. The module is designed to meet industry interoperability standards for straightforward integration into existing optical networks.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• Server-to-switch connections in data centers
• Short- to medium-range single-mode fiber links
• Network upgrades where 10GbE ports are required

Key specifications

• Form factor: SFP+
• Data rate: 10 Gbit/s
• Wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Range: short to medium optical transmission
• Interface: 10GbE-compatible optical port
• Installation: hot-pluggable

How to use

Insert the SFP+ transceiver into a compatible 10GbE SFP+ slot on a switch, router, or server until it clicks into place. Connect a single-mode optical fiber cable with appropriate LC connectors to the module’s optical interface. Verify link status via device LEDs or management interface and configure network settings as required for your environment. To remove the module, release the latch and pull the transceiver straight out while the system is powered on if hot-swap is supported.

Recommendations

Use the module with single-mode fiber and LC-terminated patch cables for best performance at 1310 nm. Check compatibility with the host device firmware and supported transceiver lists before installation. Protect the optical ports with dust caps when not in use and handle the transceiver by its housing to avoid contamination of the optical interface.