SFP+-lähetin-vastaanotinmoduuli CBO 100-01971-BO 10 Gbit/s 1550 nm

The SFP+ Transceiver Module CBO 100-01971-BO 10 Gbit/s 1550 nm is an optical communications component designed for installation in compatible SFP+ ports on switches, routers and servers. It supports a 10 Gbit/s data rate over a 1550 nm wavelength and is intended for single-mode fiber links that require long-distance transmission. The module is hot-pluggable and provides a compact interface for establishing high-speed optical connections in enterprise and carrier environments.

Advantages

This SFP+ transceiver offers a stable 10 Gbit/s throughput on a 1550 nm wavelength suitable for single-mode fiber, enabling long-reach links without changes to active equipment. Its hot-pluggable design simplifies upgrades and replacements without powering down systems. The form factor and standardized interface ensure broad compatibility with SFP+ ports on network equipment supporting optical modules.

Suitable for

• Long-distance point-to-point single-mode fiber connections
• High-speed uplinks between switches and routers
• Optical links for data center servers and storage networks
• Telecom and carrier transport where 1550 nm transmission is required

Key specifications

• Nominal data rate: 10 Gbit/s
• Operating wavelength: 1550 nm
• Media type: single-mode fiber (SMF)
• Form factor: SFP+ hot-pluggable transceiver
• Connector type: standard fiber optical connector interface
• Intended use: long-reach optical links

How to use

Install the transceiver into a compatible SFP+ slot following the equipment manufacturer’s instructions, ensuring the device is powered and the port supports 10 Gbit/s optical modules at 1550 nm. Connect single-mode fiber cables with the appropriate connector type, verify link status through the host device management interface and monitor optical parameters if available. Replace or upgrade modules while the system is running if the host supports hot-plug operation to minimize downtime.

Recommendations

Verify optical budget and distance requirements for 1550 nm transmission in your network design, and use appropriate fiber type and attenuators where necessary. Consult the network equipment compatibility list and test link integrity after installation to ensure expected performance.