BlueOptics SFP28-AOC-15M-EN-BO InfiniBand-kuituvalokaapeli 15 m uros/uros

The BlueOptics SFP28-AOC-15M-EN-BO InfiniBand fibre optic cable 15m Male/Male is a 15-metre active optical cable with SFP28 connectors, designed for high-speed data links in data centers and networking racks. It uses an active optical design with integrated transmitter and receiver elements in each connector to transmit optical signals over multi-mode fiber, supporting up to 25 Gbps per lane in compatible systems. The male-to-male SFP28 connection follows MSA-compatible physical form-factor conventions and is intended for direct device-to-device links where an SFP28 port is available on both ends.

Advantages

This active optical cable provides a lightweight, low-power alternative to traditional copper cables for short to medium-length interconnects. Its SFP28-to-SFP28 design reduces cabling complexity by enabling direct connections between compatible switches, routers and storage devices while minimising signal loss over the 15 m distance. Because the cable integrates optical transceivers at each end, it supports high-speed protocols such as 25G Ethernet and related Fibre Channel over Ethernet or SDH/SONET scenarios when used with hardware that accepts compatible SFP28 AOC modules.

Suitable for

• Interconnects between switches and routers with SFP28 ports in data centres
• Connections to storage systems and server NICs supporting SFP28
• High-speed uplinks and fabric links within rack and row cabling
• Short to medium distance 25G Ethernet or compatible InfiniBand links

Key specifications

• Length: 15 metres
• Connector type: SFP28 male to SFP28 male
• Cable type: Active optical cable with integrated transmitter and receiver
• Supported link speed: up to 25 Gbps per lane (protocol dependent)
• Optical medium: multi-mode fibre (integrated within AOC)

How to use

Ensure both devices have powered and compatible SFP28 ports that support active optical cable modules. Handle the cable by the connector bodies and avoid sharp bends along the fibre line; maintain the minimum bend radius recommended by the equipment vendor. Insert each SFP28 connector straight into the SFP28 port until the latch engages and verify link status through device LEDs or management interfaces. For removal, release the latch and withdraw the connector while supporting the cable to avoid stress on the port.

Recommendations

Use the BlueOptics SFP28-AOC-15M-EN-BO in supported hardware platforms that accept SFP28 AOC modules and within the specified 15 m reach. Keep the connectors clean and protected when not in use, avoid excessive bending or twisting, and verify firmware or compatibility notes for your specific switch, router or storage vendor to ensure full interoperability with 25G and related protocols.