Bosch Expert SDS Clean plus-8X -poravasara 14 mm, työpituus 200 mm

The Bosch Expert SDS Clean plus-8X rotary hammer drill bit with a 14 mm diameter and 200 mm working length is a carbide-tipped bit engineered for drilling in concrete and masonry. Designed for use with SDS-compatible rotary hammers, its shank provides secure engagement and efficient energy transfer. The length enables deeper anchoring, through-holes and installation work while the carbide tip and optimized flute geometry support effective dust removal and prolonged cutting performance.

Advantages

This drill bit combines a hard-wearing carbide tip with an SDS shank to deliver reliable penetration into concrete and masonry. The 200 mm working length allows drilling deeper holes without changing to extensions, and the flute design assists in clearing debris to maintain drilling efficiency. The consistent geometry ensures stable guidance and reduces the risk of bit deviation during use.

Suitable for

• Drilling anchor and fixing holes in concrete and solid masonry
• Through-holes for pipe and cable installation
• Preparation of holes for dowels and threaded anchors
• Construction and renovation tasks requiring deeper drilling

Key specifications

• Tip material: carbide-tipped for improved wear resistance and cutting efficiency
• Shank type: SDS-compatible shank for secure tool engagement and quick bit changes
• Diameter: 14 mm suitable for common anchor and fixing sizes
• Working length: 200 mm for deeper hole applications
• Intended material: concrete and masonry
• Flute design: optimized for debris removal and stable drilling

How to use

Insert the SDS shank fully into the rotary hammer chuck until it locks, then set the tool to hammer drilling mode if available. Position the bit perpendicular to the work surface, apply consistent forward pressure and start at low speed to establish the hole, increasing speed as the bit progresses. Withdraw periodically to clear dust and prevent overheating when drilling deep holes. After completion, clean the hole of debris before inserting anchors or fixings.

Recommendations

Use appropriate personal protective equipment, including safety glasses, hearing protection and a dust mask. For reinforced concrete, verify reinforcement location before drilling. Match drill diameter to anchor or fixture specifications and avoid excessive side loads to prolong bit life.