Bosch työkalutarvike 2609255417 pituus 120 mm

Concrete drill bit set including five carbide-tipped masonry bits in common sizes: 5.0×85 mm, two 6.0×100 mm, 8.0×120 mm and 10.0×120 mm. The set complements Bosch power tools and accessories and is intended for drilling into concrete, brick and other masonry materials. The bits are sized to fit standard hammer drills and rotary percussion drills used in construction and repair work.

Advantages

The bits feature carbide tips for improved wear resistance and consistent drilling performance in masonry. Multiple diameters and lengths cover typical hole sizes for anchors, dowels and conduit entry. Compatibility with Bosch tool accessory interfaces ensures secure mounting and stable operation. The set offers straightforward selection of common masonry drill sizes without requiring individual purchases.

Suitable for (tasks / use cases)

• Drilling holes in concrete and brick for anchors and plugs
• Creating entry points for electrical conduit and plumbing through masonry
• Site repair and renovation work requiring standard masonry hole sizes

Key specifications

• Contents: 5 masonry drill bits — 5.0×85 mm, 6.0×100 mm (×2), 8.0×120 mm, 10.0×120 mm
• Tip material: carbide
• Intended material: concrete, brick, masonry
• Manufacturer: Bosch
• Manufacturer part number (MPN): 2609255417
• EAN: 3165140384599

How to use

Select the drill bit with the required diameter and insert it into a compatible hammer or rotary-percussion drill chuck. Use the hammer function for concrete and hard masonry; use rotary-only mode for softer materials if available. Start drilling at low speed to position the bit, then increase speed and apply steady pressure without forcing. Withdraw the bit periodically to clear dust and prevent overheating. Follow the drill manufacturer's safety and operating instructions.

Recommendations

Use appropriate personal protective equipment (safety glasses, dust mask, hearing protection) and secure workpieces before drilling. Match bit diameter to anchor or plug size and avoid side loads; replace bits that show excessive wear or damaged carbide tips.