Creality CR-200B LED-valonauha CREALITY 3D-ZUBEHÖR

For CR-200B owners tired of squinting at the print bed, this LED light bar slips on in seconds with its magnetic base and floods the build area with crisp, shadow-free daylight. Unlike generic USB lamps that sag or shift, the aluminium alloy housing stays rigid and doubles as a heat sink, keeping all 18–24 LEDs cool for a lifespan beyond 20,000 hours.

Highlights

• Tool-free magnetic adsorption mounting – no brackets, screws, or tape
• USB-A powered from any 5V DC source, including the printer’s own port
• Daylight white 6000–6500K colour temperature for true-to-life print inspection
• 250 lumens output across a wide, even beam – no hot spots
• Inline on/off switch for instant control without unplugging
• Aluminium alloy + PC construction resists heat and warping
• 1.2 m cable reaches from printer base to top frame or enclosure

In daily use

Mount the bar on the top rail or side of your Creality enclosure, plug it into a spare USB-A port, and flip the switch. The magnetic base holds firmly even during fast print moves, yet you can reposition it in a second when switching between tall and flat prints. The 3 W power draw is negligible, so it won’t strain your printer’s PSU or a standard USB wall adapter. Whether you’re checking first-layer squish, monitoring a 20-hour print, or filming a timelapse, the 6000–6500K daylight spectrum reveals every detail without the blue cast of cheap LEDs.

Full specifications

• Light source: 18–24 high-efficiency LEDs
• Colour temperature: 6000–6500K (daylight white)
• Luminous flux: 250 lumens
• Power interface: USB-A
• Input voltage: DC 5V
• Power consumption: 3 W
• Mounting: magnetic adsorption
• Bar material: aluminium alloy, PC
• Cable length: 1.2 m
• Switch: inline on/off
• Lifespan: >20,000 hours
• Compatibility: Creality CR-200B, CR-10, Ender-3, Ender-5, and similar enclosures or frames

Final note

This is the same light bar supplied as a Creality accessory for the CR-200B enclosure. It works with any 5V USB source, so you can also use it on a desk, workbench, or inside a DIY printer cabinet. No software, no drivers – just plug, stick, and see your prints clearly.