Dekalin Dekasyl MS-2 6252012 -monikäyttöliima ja -tiiviste, musta, 290 ml

Dekasyl MS-2 is a multifunctional adhesive and sealant and is suitable for creating elastic connections between components where high adhesive strength is additionally required.

• UV and ageing resistant
• Neutral, odourless and fast curing

Dekasyl MS-2 from Dekalin (MPN 6252012) is a multifunctional adhesive and sealant. It is a good compromise between adhesive and sealant for demanding work. The elastic adhesive and sealant is suitable for creating elastic connections between components where high adhesive strength is additionally required. Application on glass, side skirts and wheel arch liners does not require prior surface treatment. Overpainting is possible after skin formation.

• Application areas
• Elastic connections and seals in caravan and motorhome construction
• Bonding of roofs on buses, caravans and motorhomes
• Bonding of edge profiles of trailers with aluminium or polyester
• Bonding of polyester parts with metal frames
• Bonding of floor systems
• Sealing of weld seams
• Properties
• Free of solvents, isocyanate and PVC
• Very good UV and ageing resistance

Generally good adhesion without primer on various substrates, e.g. Dekasyl MS-2 can be used as a sealant for PVC floor coverings

• Permanently elastic in the temperature range from -40°C to +120°C

Can be overpainted after skin formation (wet on wet), this generally does not affect curing

Compatible with most industrial coating or painting systems, both alkyd resin and dispersion paints

• Adhesion

In general, Dekasyl MS-2 adheres well without primer to clean, dry, dust- and grease-free substrates made of aluminium, stainless steel, galvanised steel, zinc, copper, brass, powder-coated metal, most painted metal surfaces, glass, PVC, polyester (GRP), painted and varnished wood, etc. No adhesion without pre-treatment on polyethylene, polypropylene and Teflon®. If high adhesion is required in cases of large thermal or physical loads, especially in humid environments, the use of a primer is recommended.

• Processing

Dekasyl MS-2 can be easily processed with a hand or air pressure gun at temperatures from +5°C to +35°C. For sealing, Dekasyl MS-2 should be further processed or smoothed within 10 minutes (at 20°C/50% rel. humidity) with a spatula or putty knife previously dipped in mild soapy water. Avoid penetration of the soapy water between the joint sides and the sealant, as this leads to a loss of adhesion. For bonding, the substrates must be assembled within 15 minutes (at 20°C/50% rel. humidity) after applying Dekasyl MS-2. The higher the temperature, the shorter the processing time! In general, an adhesive layer of 2mm is recommended if similar materials (with similar strength) are to be bonded. The greater the difference in thermal expansion, the thicker the adhesive layer should be. At a temperature of 20°C and a relative humidity of 50%, Dekasyl MS-2 can be overpainted with most industrial paints after just 10 minutes. The best possible adhesion of paint layers is achieved when the paint is applied 4 hours after application of Dekasyl MS-2. Clean tools or remove uncured residues of Dekasyl MS-2 with a clean, colourless cloth soaked in acetone or MEK (it is recommended to check beforehand whether the surface is attacked by these cleaners).

• 1x Dekalin Dekasyl MS-2, 290ml cartridge, black