DMX-kaapeli EUROLITE EC-1 IP65 3-napainen, 3 m, musta

EUROLITE EC-1 IP65 3‑pin DMX cable, 3 m in black, provides a sealed connection for transmitting DMX control signals where splash and dust resistance are required. The cable combines standard 3‑pin DMX connectivity with an IP65-rated construction to maintain signal integrity in protected outdoor environments and indoor installations. It is intended for use with DMX controllers, lighting fixtures and dimmers that accept 3‑pin XLR connections.

Advantages

The IP65 rating ensures protection against water jets and dust ingress at the connection points, reducing the risk of interruptions during events. A 3 m length offers a practical balance between reach and manageable cable runs, while the three-pin configuration preserves compatibility with a wide range of DMX equipment. The black jacket provides a discreet appearance suitable for stage and architectural installations, and the cable construction is optimized to reduce signal loss and interference.

Suitable for

Key specifications

How to use

Ensure both the DMX controller and the lighting fixture or dimmer are powered off before connecting. Align the 3‑pin connectors, insert fully and secure any locking mechanism if present to maintain the IP65 seal at the connection. Route the cable to avoid sharp edges, excessive bending or heat sources, and use appropriate cable management to prevent strain on connectors. When connecting multiple fixtures in a chain, maintain correct DMX addressing and termination practices for reliable signal transmission.

Recommendations

Regularly inspect connectors and the outer jacket for damage, especially after outdoor use. Clean connection surfaces to preserve the IP65 sealing function and replace the cable if the protective jacket or connector seals are compromised. For fully exposed outdoor installations, consider additional weatherproofing measures or cables specified for continuous outdoor exposure.