DMX RDM -splitteri EUROLITE DXT-SP 1in/2out (malli 70064866)

EUROLITE DXT-SP 1in/2out DMX RDM splitter reliably distributes a single DMX/RDM input to two electrically isolated outputs. Designed for professional lighting setups, the device preserves signal integrity while preventing interference and ground loop issues between separate DMX runs. Its compact housing and standard connectors make it suitable for stage, installation, and touring environments where one lighting controller must feed multiple DMX lines.

Advantages

The splitter provides galvanic isolation between outputs to protect fixtures and controllers from voltage differences and short circuits on separate lines. It maintains correct termination and signal buffering to ensure stable transmission of DMX and RDM data. Construction is compact and robust for rack or flight-case use, and the unit supports hot swapping and simple plug-and-play operation without complex configuration.

Suitable for

Key specifications

How to use

Connect the DMX/RDM source to the input connector and route each output to the separate DMX lines or fixtures. Ensure proper cable shielding and use industry-standard DMX cables. The unit requires no software setup; once connected it buffers and isolates the signals so the controller can address devices on both outputs independently. Check LED indicators (if present) to confirm signal presence and correct operation before show start.

Recommendations

Place the splitter close to the controller or in a central distribution point to minimize trunk cable lengths. Always use quality, shielded DMX cables and observe proper termination practices at the ends of each DMX run. For touring use, protect the unit in a flight case and verify isolation when connecting equipment with different power sources.