SO-DIMM 8 GB DDR3-1600 (2x 4 GB) Dual-Kit (F3-1600C11D-8GRSL, Ripjaws)

The G.SKILL Ripjaws SO-DIMM kit (F3-1600C11D-8GRSL) provides 8 GB of DDR3 memory in a 2×4 GB dual-channel configuration at 1600 MHz with CAS latency 11. Designed for laptops and small form-factor systems, this 204-pin SO-DIMM kit operates at 1.35 V to reduce power consumption and heat while improving overall responsiveness for multitasking, gaming, programming and multimedia work on systems with 3rd- and 4th-generation Intel Core processors that support 1.35 V DDR3 SO-DIMM.

Advantages

G.SKILL Ripjaws SO-DIMM modules are 100% validated through manufacturer burn-in testing to ensure stability and consistent performance. The low-voltage 1.35 V design lowers power draw and operating temperature compared with standard DDR3 modules, which helps extend laptop battery life and maintain system stability under load. The dual-channel 2×4 GB configuration enables improved memory throughput for common laptop workloads.

Suitable for

• Upgrading laptop memory for smoother multitasking
• Gaming on laptops that support DDR3 SO-DIMM
• Programming and software development
• Multimedia editing and playback
• Systems with Intel 3rd or 4th Gen Core processors supporting 1.35 V DDR3 SO-DIMM

Key specifications

• Model: G.SKILL Ripjaws F3-1600C11D-8GRSL
• Capacity: 8 GB (2 × 4 GB)
• Memory type: DDR3
• Speed: 1600 MHz
• CAS latency: CL11
• Form factor: 204-pin SO-DIMM
• Voltage: 1.35 V
• EAN: 4711148599955

How to use

Power off the laptop and disconnect the power source and battery if possible. Access the memory compartment according to your laptop manufacturer’s instructions, then carefully remove the existing SO-DIMM(s) if upgrading. Align the notch on the G.SKILL SO-DIMM with the slot, insert at a slight angle and press down until the module clicks into place. Reassemble the laptop, reconnect power, and verify the new memory is recognized in BIOS/UEFI or the operating system.

Recommendations

Install memory in matched pairs for dual-channel operation, and confirm BIOS/UEFI settings and motherboard/laptop documentation to ensure compatibility with 1.35 V DDR3 SO-DIMM modules prior to installation.