InfiniBand/kuitu kaapeli BlueOptics XLDACBL5 5 m QSFP

The BlueOptics XLDACBL5 5 m QSFP InfiniBand/fibre optic cable is designed for high-speed data transfer in data centers and networking environments. This 5-metre cable features QSFP connectors on both ends and supports low-latency, reliable connections between switches, servers and storage systems. Its construction aims to maintain signal integrity over short to medium link distances while simplifying installation in rack-mounted and clustered configurations.

Advantages

The cable provides a standardized QSFP interface on both ends to ensure compatibility with QSFP-enabled network equipment. Its 5 m length balances reach and manageability for typical rack-to-rack or chassis-to-chassis connections. The BlueOptics design focuses on signal quality and minimal transmission loss to support high throughput and reduced error rates. The cable's flexibility and jacket construction help route the cable through dense cabling channels without stressing connectors.

Suitable for

Key specifications

How to use

Ensure both devices support QSFP interfaces and are powered down or set to allow hot-plugging per device guidelines before insertion. Align the QSFP connector with the port and insert evenly until the module seats; secure any retention mechanism if present. Route the cable to avoid sharp bends and maintain the minimum bend radius specified by the equipment vendor. For removal, release the connector latch or retention mechanism and withdraw the cable straight out to avoid damaging the connector or port.

Recommendations

Store and handle the cable in a clean environment to prevent contamination of fibre interfaces. Avoid exceeding recommended bend radii and protect connector ends with dust caps when not in use. Verify compatibility with QSFP-supported equipment and follow vendor guidelines for link configuration and optical transceiver settings where applicable.