InLine nippuside tarranauhalla 25 mm musta 25 m

InLine Cable Ties with Hook-and-Loop Fastener Band 25 mm Black 25 m are a reusable felt fastening solution designed for bundling, organizing and securing cables, hoses and other lines. Supplied as a single 25 m roll in black, the product consists of two complementary strips — one loop-side and one hook-side — that can be cut to the required length and fastened around cable bundles or objects. The 25 mm width provides a stable hold while allowing flexibility for repeated opening and closing.

Advantages

The hook-and-loop construction enables repeated use without damaging cables or insulation and eliminates the need for single-use plastic ties. The felt material is gentle on surfaces and reduces abrasion, while the 25 mm width offers balanced strength and flexibility for a wide range of cable diameters. Supplied as a 25 m roll, the solution is adaptable: users cut pieces to length, which minimizes waste and supports custom organisation of cable runs.

Suitable for

• Bundling and securing power, network and audio/video cables in offices and data centres
• Organising cables and hoses in workshops, garages and production areas
• Temporary or adjustable cable management behind desks, entertainment units or server racks
• Home use for cable tidying, extension leads and appliance cords
• Environments where reusable, non-abrasive fastening is preferred over disposable ties

When it may not be suitable

This hook-and-loop felt band is not intended for permanent outdoor installations exposed to prolonged sunlight, heavy moisture or chemical environments; prolonged exposure may reduce adhesion and material life. It is also not designed for securing very heavy loads or for safety-critical supports where certified mechanical fasteners are required.

Key specifications

• Material: felt with hook-and-loop fastening surfaces
• Width: 25 mm
• Length: 25 m (roll)
• Colour: black
• Design: two complementary strips (hook-side and loop-side) for cutting to length

How to use

Measure the required length around the cable bundle or object, then cut the hook-and-loop band from the roll using scissors. Place the loop-side and hook-side around the items to be secured and press the surfaces together to fasten. Adjust tension as needed and open by peeling the strips apart for repositioning or reuse. For neat routing, cut multiple short pieces and apply at intervals along the cable run.

What to consider before purchase

• Intended environment: indoor use is recommended; avoid prolonged outdoor exposure
• Required holding strength: suitable for cable management but not for heavy load bearing or safety-critical fastening
• Amount needed: supplied as a single 25 m roll — calculate total length required before cutting
• Compatibility with cable diameters: 25 mm width is suited to small and medium bundles; for very large bundles consider wider solutions

Recommendations

For organised results, cut pieces slightly longer than the bundle circumference to allow overlap, and place ties at 20–30 cm intervals along long cable runs. Regularly inspect and retighten if used in environments with frequent movement, and store the roll away from direct sunlight and moisture to maintain hook-and-loop performance.