InLine Solid asennuskaapeli SF/UTP Cat.5e AWG24 CU PVC 100m

The InLine Solid Installation Cable SF/UTP Cat.5e AWG24 CU PVC 100m is a 100-meter, solid-core network cable designed to meet Cat5e performance requirements. It features SF/UTP shielding to reduce electromagnetic interference and is made from copper conductors (CU) with a PVC outer jacket in beige. This cable is intended for fixed installations in residential and commercial environments where reliable data transmission and adherence to Cat5e standards are required.

Advantages

The SF/UTP construction provides improved protection against external interference compared to unshielded cables, supporting stable signal quality over the specified distance. Solid AWG24 copper conductors offer consistent electrical characteristics for permanent installation in walls, conduits, and structured cabling systems. The PVC sheath ensures mechanical protection and ease of handling during installation while the 100 m spool length is suitable for typical room-to-room and floor cabling runs.

Suitable for

• Structured cabling for offices and homes
• Data and Ethernet installations up to Cat5e performance
• In-wall and conduit runs in new or renovated buildings
• Networks where additional shielding is required to limit interference

Key specifications

• Cable category: Cat5e
• Conductor type: Solid copper (CU)
• Conductor size: AWG24
• Shielding: SF/UTP (foil + braided screen with overall unshielded pairs)
• Sheath material: PVC
• Length: 100 m
• Colour: Beige

How to use

Plan the cable route and confirm compliance with local building and fire codes for in-wall installations. Cut the required length from the spool and strip the outer PVC sheath and pair insulation carefully to avoid nicking the conductors. Terminate the solid AWG24 conductors on appropriate keystone jacks or patch panels rated for Cat5e, following standard wiring schemes (T568A or T568B). Ensure the shielding is properly grounded at one end or per site grounding practices to maintain the SF/UTP effectiveness. Test each run with a cable tester to verify continuity, pair integrity and category performance before finalizing the installation.

Recommendations

The cable is intended for fixed installation only; do not use it as a patch cord. Avoid excessive bending radii and mechanical stress during pulling. Keep the cable separated from high-voltage power lines and sources of strong electromagnetic interference where possible. For installations that require plenum-rated or low-smoke zero-halogen materials, select an alternative sheath that complies with applicable fire-safety regulations.