Jatkojohto EUROLITE 3x1,5 mm², 3 m, malli 30245695

The EUROLITE extension cable 3x1.5 mm², 3 m is a flexible three-core mains lead intended for extending power connections for lighting fixtures and electrical devices where moderate current capacity is sufficient. The 3-metre length provides extra reach for temporary installations, stage and event setups, workshop tasks, and general indoor use. The cable is designed for straightforward connection and routing, offering a practical solution when a short extension between power source and equipment is required.

Advantages

This extension cable combines a practical 1.5 mm² conductor cross-section with a flexible outer sheath to balance current capacity and ease of handling. Its three-core design supports live, neutral and earth connections for standard mains-powered devices. The 3 m length reduces the need for multiple connectors and minimizes cable clutter in close-range setups. The cable is suitable for repeated laying and removal in temporary applications and is compatible with typical mains connectors used in indoor environments.

Suitable for

Key specifications

How to use

Verify that the connected equipment's current draw does not exceed the safe rating for 1.5 mm² conductors and ensure compatibility with local mains voltage. Route the cable to avoid sharp edges, heat sources and tripping hazards, and connect live, neutral and earth conductors to the corresponding terminals of compatible plugs or sockets following local electrical regulations. For temporary stage or event setups, secure the cable along run paths to prevent movement and accidental disconnection. Inspect connectors and insulation before each use and replace the cable if visible damage is present.

Recommendations

Use this cable for indoor and temporary power extension where a 3 m reach and 1.5 mm² conductor cross-section are appropriate. Do not use the cable in permanent outdoor installations or for loads that exceed the safe current capacity of 1.5 mm² conductors. Always follow local wiring regulations and, when in doubt, consult a qualified electrician for installation and load calculations.