Tili Ota yhteyttä
Ostoskorisi
Toimitus DPD & FedEx
Tarvitsetko apua? Kysy AI:lta

Kaapeli CBO BlueOptics CBL-410-BO 10 m QSFP uros–uros 40 Gbit/s

Kaapeli CBO BlueOptics CBL-410-BO 10 m QSFP uros–uros 40 Gbit/s
Kaapeli CBO BlueOptics CBL-410-BO 10 m QSFP uros–uros 40 Gbit/s
199,37 €
Cable CBO BlueOptics CBL-410-BO 10 m QSFP Male–Male 40 Gbit/s is a copper/active direct attach cable designed for short- to medium-reach, high-speed interconnections. With QSFP male connectors on both ends and a 10-metre length, this cable supports 40 Gbit/s links between switches, servers and other... Lue lisää
Varasto 5 Tuotekoodi 1471810 Merkki BLUEOPTICS Malli CBL-410-BO Takuu 2 vuotta

Toimitus ja palautukset

Arvioitu toimitusaika Torstai, Lokakuu 22
Saat päivitykset yksityiskohtaisen seurantajärjestelmän kautta
Maksuvaihtoehdot
MaksukorttiVisaMastercardPayPalApple PayGoogle PayTilisiirto

Cable CBO BlueOptics CBL-410-BO 10 m QSFP Male–Male 40 Gbit/s is a copper/active direct attach cable designed for short- to medium-reach, high-speed interconnections. With QSFP male connectors on both ends and a 10-metre length, this cable supports 40 Gbit/s links between switches, servers and other QSFP-equipped network devices. It is intended for use in data centre top-of-rack, aggregation and server-to-server connectivity where reliable, low-latency transmission and simplified cabling are required.

Advantages

The cable provides a compact, single-assembly solution for 40 Gbit/s connections without the need for separate transceivers, reducing component count and simplifying installation. Active copper construction helps maintain signal integrity over the 10 m length and supports low-latency data transfer suitable for demanding networking environments. Its QSFP male–male form factor is compatible with standard QSFP ports, enabling straightforward plug-and-play deployment in compatible equipment.

Suitable for

Key specifications

How to use

Install the cable by inserting each QSFP male connector into compatible QSFP ports on the devices to be linked. Ensure both endpoints are powered down or that hot-plugging is supported by your equipment before insertion, then verify link status via device LEDs or management interfaces. For optimal performance, avoid sharp bends and maintain proper cable routing to prevent strain on connectors. Use compatible port settings on switches and servers to enable 40 Gbit/s operation and, if necessary, configure link aggregation or VLAN settings according to network design.

Recommendations

Use this cable for short- to medium-range 40 Gbit/s connections inside racks and between adjacent racks. Keep cable runs tidy with proper management to preserve signal integrity and avoid exceeding the recommended bend radius. Verify compatibility with device QSFP ports and firmware versions when deploying in mixed-vendor environments.

Tärkeimmät ominaisuudet
  • Data centre top-of-rack and aggregation links
  • High-bandwidth server interconnects and clustering
  • Switch-to-switch connections within racks or adjacent racks
  • Short- to medium-distance connections in enterprise and carrier networks
  • Connector type: QSFP male–male
  • Length: 10 m
  • Cable type: copper / active Direct Attach Cable (DAC)
  • Maximum data rate: 40 Gbit/s
  • Typical application: short- to medium-reach high-speed links
  • Latency: low, suitable for time-sensitive traffic
Tekniset tiedot
Kaapelin pituus
10 m
Liitin 1
QSFP
Liitin 2
QSFP
Hintahistoria viimeisen 6 kuukauden ajalta
Kaapeli CBO BlueOptics CBL-410-BO 10 m QSFP uros–uros 40 Gbit/s
Nykyinen
199,37 €
Alin
199,22 €
Ylin
208,83 €
Muutos 24 h
-0,00 €   0%
Viikko
-1,71 €   -1%
Kuukausi
-1,41 €   -1%

Suositut tuotteet tässä kategoriassa

Hei, olen DistriNoden tekoälyavustaja. Autan sinua löytämään tuotteita, vertailemaan vaihtoehtoja, laatimaan tarjouksia PDF-muodossa tai tekemään tukipyyntöjä.