Kaapelikanava / johdotuskanava DELOCK 22025 16 x 16 mm, pituus 1 m, harmaa

DELOCK 22025 is a 1 m long wiring channel with internal dimensions of 16 x 16 mm in grey, designed to route and protect low-voltage cables and wires. The slim profile fits along walls, skirting boards or under desks to keep power, data and AV cabling organised and concealed. Constructed for simple surface mounting, this cable duct provides a compact solution where space is limited and neat cable management is required.

Advantages

The DELOCK wiring channel offers a narrow footprint while providing full separation and protection for small-diameter cables. Its neutral grey colour blends with many interior environments. The smooth interior reduces abrasion and simplifies cable insertion, and the rigid but lightweight material supports easy cutting to length and secure fastening. Installation is fast and unobtrusive, enabling a tidy appearance without invasive wall work.

Suitable for

• Routing low-voltage power, Ethernet, HDMI and audio cables along walls or furniture
• Concealing wires under desks, behind monitors or near entertainment centres
• Small office, home office and residential cable management
• Temporary or semi-permanent cable runs where minimal visual impact is desired

Key specifications

• Internal cross-section: 16 x 16 mm
• Length: 1 metre
• Colour: grey
• Profile type: rectangular wiring channel for surface mounting
• Material characteristic: rigid, lightweight plastic suitable for trimming

How to use

Measure the run and mark the mounting positions along the wall or furniture. Cut the duct to the required length with a fine saw or plastic cutter and smooth any rough edges. If needed, pre-route cables through the channel before final assembly or open the channel if it has a removable cover. Secure the duct to the surface using appropriate screws or adhesive recommended for the mounting substrate, ensuring the channel is level and continuous for long runs. Insert cables into the channel and close the cover if applicable, leaving gentle bends to avoid strain on connectors.

Recommendations

For best results use the duct for low-voltage cabling only and avoid running mains-voltage conductors together with signal or data cables inside the same small channel. Select mounting hardware compatible with your wall type; on delicate surfaces consider double-sided mounting tape or cable clips. When planning multiple cable runs, leave adequate space for future additions and avoid exceeding the internal area with too many thick cables to maintain airflow and prevent crushing.