Koaksiaalikaapeli ShiverPeaks BS80305 5 m F valkoinen

The ShiverPeaks BS80305 coaxial cable is a 5 m cable with F-type connectors on both ends, designed for reliable audio and video signal transmission. Its white outer jacket provides a neutral appearance suited to home and professional installations. The cable construction supports stable connections between antennas, set-top boxes, satellite receivers and other RF equipment while maintaining signal integrity over the 5 meter length.

Advantages

This coaxial cable offers a standardized F-connector interface on both ends for compatibility with common RF devices. The 5 meter length provides flexibility for placement without needing signal boosters in typical residential setups. The white jacket helps the cable blend into indoor environments, and the construction is intended to resist routine wear and maintain consistent electrical contact at connector points.

Suitable for

• Connecting TV antennas to set-top boxes or televisions
• Linking satellite receivers to wall outlets or distribution points
• Interconnecting radio frequency devices and amplifiers in home installations
• Temporary or permanent indoor cable runs where a white finish is preferred

Key specifications

• Cable type: coaxial with F-type male connectors on both ends
• Length: 5 metres
• Outer jacket colour: white
• Intended use: audio/video and RF signal transmission
• Connector interface: standard threaded F-connector compatible with common TV and satellite equipment

How to use

Connect one F-type connector to the output of your antenna, satellite dish or RF source and securely screw the other connector onto the input of the receiving device such as a television, set-top box or receiver. Ensure connectors are tightened by hand until snug to maintain good contact; avoid overtightening with tools to prevent damage to connector threads. Route the cable to avoid sharp bends and keep it away from sources of electrical interference for optimal signal quality.

Recommendations

For best results in indoor installations, run the cable along baseboards or behind furniture to reduce strain. If longer runs or outdoor routing are required, consider using a cable rated for lower signal loss or weather-resistant jackets. Inspect connector ends periodically to ensure a clean, corrosion-free contact and replace the cable if any physical damage or degraded signal quality is observed.