Kosketusnäyttö FlashForge 13,3 tuumaa — Flashforge vara-kosketusnäyttöpaneeli, malli 20002160001

Replacement touchscreen panel for the FlashForge Foto 13.3" 3D printer (model 20002160001). This original FlashForge-branded spare part restores the printer's touchscreen interface used for adjusting settings, starting and stopping prints, and navigating menus. The component is intended for repair or upgrade of the Foto 13.3" to regain full touchscreen functionality and responsive user interaction.

Advantages

The original FlashForge touchscreen offers direct compatibility with the Foto 13.3" model and matches the factory specifications for fit and interface responsiveness. Using a manufacturer-branded panel reduces the risk of compatibility issues compared with generic alternatives and helps maintain the printer’s original user experience.

Suitable for

• Repairing a non-responsive or damaged Foto 13.3" touchscreen
• Replacing a cracked or scratched display on FlashForge Foto 13.3"
• Upgrading a Foto 13.3" with a factory replacement part to restore full functionality

Key specifications

• Brand: FlashForge
• Model / MPN: 20002160001
• Compatible printer: FlashForge Foto 13.3"
• Type: Replacement touchscreen panel
• EAN: 6971940405702

How to use

Power off the FlashForge Foto 13.3" and disconnect it from the mains before beginning replacement. Remove the printer's front panel or bezel according to the manufacturer's service instructions, disconnect the old touchscreen ribbon and connectors, and install the new panel in the same orientation. Reconnect all cables securely, reassemble the bezel, and power on the printer. Verify touchscreen operation by navigating the menus and running a test print or touchscreen calibration if available.

Recommendations

Handle the replacement panel and internal connectors with care to avoid static damage. If you are not experienced with printer disassembly, consider professional service or consult FlashForge support to ensure correct installation and preserve warranty conditions.