Kotelo SCHROFF 10225-601 — alumiinikotelo IP-suojauksella

The SCHROFF 10225-601 enclosure is an aluminum housing designed to provide IP-rated protection for electronic equipment. Constructed from lightweight yet durable aluminum, the enclosure creates a sealed environment that reduces the ingress of dust and moisture while offering a stable mechanical platform for mounting PCBs, connectors and small modules. Its design targets industrial, telecommunications and laboratory installations where reliable environmental protection and straightforward integration are required.

Advantages

The aluminum construction balances strength with reduced weight, improving handling and reducing load on mounting structures. The IP-rated sealing minimizes contamination risks from dust and splashes, supporting longer component life and consistent electrical performance. The housing offers a plain interior and standardized mounting faces that simplify installation of brackets, rails or custom panels. Its corrosion-resistant surface and thermal conductivity assist in passive heat dissipation for low- to moderate-power electronics.

Suitable for

• Industrial control modules and sensors
• Telecom and network interface modules
• Laboratory instruments and measurement electronics
• Embedded computing boards and small power supplies
• Prototyping and field-deployable assemblies requiring sealed protection

Key specifications

• Enclosure material: aluminum
• Protection level: IP-rated sealing against dust and moisture (IP class as specified by the system design)
• Construction: rigid housing with flat mounting faces and sealed joining points
• Surface finish: corrosion-resistant treatment suitable for industrial environments
• Thermal behavior: aluminum body provides passive heat spreading for low- to moderate-power components
• Mechanical properties: lightweight yet mechanically stable for mounting electronic assemblies

How to use

Mount the enclosure on a suitable support using its external fixing points or integrate it into a rack or cabinet as required by the installation. Prepare internal panels, mounting rails or brackets to secure PCBs, connectors and wiring; ensure cable entry points are closed with appropriate grommets or sealed glands to maintain the IP protection. When fitting components, allow clearance for connectors and thermal ventilation; tighten fasteners to recommended torque values for a sealed joint without deforming the housing. Verify sealing after assembly with a visual inspection and, where applicable, with leak or ingress tests following site procedures.

Recommendations

For best results, select cable glands and panel interfaces rated to the same IP class as the enclosure and maintain periodic inspections of seals and gaskets. Avoid exposing the enclosure to aggressive chemicals or mechanical impacts that could compromise the protective coating or deform the housing.