Kuitu-lähetin-vastaanotinmoduuli BlueOptics ASG0000SX-BO SFP LC alumiini 20 g

The BlueOptics ASG0000SX-BO SFP LC Aluminium 20g is a fiber optic transceiver module designed for single‑module small form‑factor pluggable (SFP) installations. It supports 1000Base‑SX optical transmission over multimode fiber using an 850 nm transmitter and receiver and uses an LC duplex connector. The housing is aluminium and the module weighs approximately 20 g, providing a compact and lightweight solution for Ethernet and related optical links up to typical multimode distances.

Advantages

This BlueOptics transceiver follows MSA (Multi‑Source Agreement) specifications and offers compatibility with systems that accept analogous 1000Base‑SX SFP modules. The module supports simultaneous transmit and receive operation via LC duplex connections, and its multimode design enables short‑reach high‑speed links with low susceptibility to electromagnetic interference. Components are selected for long service life and the module includes support for digital diagnostics monitoring (DDM/DOM) when the host hardware enables that feature.

Suitable for

Key specifications

How to use

Install the BlueOptics ASG0000SX-BO into an available SFP slot on the network device until it seats firmly; avoid excessive force. Connect LC duplex multimode fiber patch cords to the module, observing transmit/receive orientation. Ensure the host device is configured for 1000Base‑SX operation and supports DDM if diagnostic monitoring is required. Power and network configuration should follow the network equipment manufacturer’s instructions. For safe handling, ground yourself to prevent electrostatic discharge and keep fiber ends clean to maintain optimal optical performance.

Recommendations

For best results, use high‑quality multimode patch cords and, where possible, OM3/OM4 fiber for improved reach and margin. Verify compatibility with the target hardware vendor’s supported transceiver list and enable DDM/DOM in the host system to monitor optics parameters remotely. Regularly inspect and clean connectors and avoid bending fiber beyond recommended radii to preserve link quality.