Kuitu-lähetin-vastaanotinmoduuli BlueOptics PU-70216-BO 10000 Mbit/s SFP+

The BlueOptics PU-70216-BO is a fiber optic SFP+ transceiver module designed for 10 Gbit/s networking applications. It supports a maximum data transfer rate of 10000 Mbit/s, uses an SFP+ interface and is finished in a silver housing with a lightweight profile of approximately 20 g. The module is intended for high-speed optical links using single-mode fiber and an LC duplex connector, and is compatible with systems that accept SFP+ transceivers for long-reach optical connections.

Advantages

The module provides 10G data throughput in a compact SFP+ form factor that fits standard SFP+ ports. Its lightweight silver housing facilitates easy handling and installation in network switches, routers and storage systems. Designed to use single-mode fiber with LC duplex connections, the transceiver supports simultaneous transmit and receive channels for bidirectional optical communication and is suitable for long-range links up to several kilometers when used with appropriate fiber cabling.

Suitable for

Key specifications

How to use

Insert the transceiver into an empty SFP+ slot of a compatible switch, router or network interface and ensure it is fully seated until the latch clicks. Connect an LC duplex single-mode fiber patch cable, observing correct orientation for transmit and receive fibers. Configure the host device port for 10G operation as required by your network equipment. Verify the optical link status via the device management interface or link LEDs and, if available, monitor diagnostic parameters through the DDM/DOM function supported by the host to check supply voltage, temperature and optical power levels.

Recommendations

Use high-quality single-mode LC duplex patch cords and adhere to the equipment vendor’s compatibility list. Ensure transceiver firmware and host software support SFP+ modules and any digital diagnostic features you plan to use. For reliable long-reach performance, inspect and clean fiber connectors before mating and choose appropriate fiber type and link budget planning for distances and attenuation.