Kuitulähetin-vastaanotinmoduuli BlueOptics E40GQSFPLR 40000 Mbit/s QSFP

The BlueOptics E40GQSFPLR 40000 Mbit/s QSFP fiber optic transceiver module provides a compact solution for high-speed optical links. Designed for use in switches, routers and transceivers that support QSFP interfaces, this module supports a maximum data transfer rate of 40 Gbit/s and is intended to enable stable, low-latency connections over appropriate fiber cabling. The form factor and electrical interface are optimized for dense installation environments where four-lane QSFP ports are available.

Advantages

This transceiver offers a high aggregate bandwidth suitable for data center uplinks and high-throughput network segments. Its QSFP interface allows straightforward integration into compatible network equipment and supports simplified cabling and hot-pluggable operation. The module’s design focuses on reliable optical transmission at 40 Gbit/s, helping maintain predictable performance for demanding network traffic.

Suitable for

Key specifications

How to use

Install the transceiver by inserting the QSFP module into a compatible port on network equipment while the host device is powered according to the vendor’s instructions. Connect appropriate fiber optic cables to the module’s optical ports, ensuring correct polarity and connector type. Verify link status through the switch or router management interface and confirm negotiated speed and operational parameters. Use vendor documentation for any required firmware or configuration steps specific to the host system.

Recommendations

Use certified optical cables and maintain clean connector endfaces to ensure signal integrity. Match the module to compatible QSFP ports and verify that the network equipment supports 40 Gbit/s operation. Monitor link health and temperature in dense installations to prevent performance degradation.