Kuitulähetin-vastaanotinmoduuli BlueOptics FTLC9555REPM-MF-BO QSFP28 100 m

The BlueOptics FTLC9555REPM-MF-BO QSFP28 100m is a fiber optic transceiver module designed for 100G high-speed data transmission over multimode fiber up to 100 meters. Housed in an aluminium enclosure and weighing approximately 40 grams, this QSFP28 module uses an MPO/MTP connector and follows MSA-compatible form factor and interface conventions to integrate with compatible network equipment. It is intended for data center and high-performance computing environments where compact, lightweight, and reliable 100G optical links are required.

Advantages

The module provides a standardized QSFP28 interface for 100GBASE-SR4 multimode operation, enabling simultaneous transmit and receive channels through an MPO/MTP connector. Its aluminium housing offers mechanical durability while keeping weight low. Built and tested to meet interoperability and MSA expectations, the transceiver supports digital diagnostics monitoring (DDM/DOM) functionality for real-time monitoring of key operating parameters when supported by the host hardware. The compact QSFP28 form factor allows high port density in switches and other networking devices.

Suitable for

Key specifications

How to use

Install the QSFP28 module into a compatible transceiver slot on the network device until it latches into place. Connect an MPO/MTP multimode fiber patch cord to the module, ensuring correct orientation and polarity of the MPO/MTP connector. Verify host device compatibility and, if required, enable or check digital diagnostics through the device management interface to monitor supply voltage, optical power and temperature. Follow the network equipment vendor instructions for hot-plugging and firmware compatibility checks.

Recommendations

Use OM3/OM4 multimode fiber patch cords and MPO/MTP cabling certified for 100GBASE-SR4 to achieve the specified 100 m reach. Ensure the host hardware officially supports QSFP28 100GBASE-SR4 modules and the DDM/DOM functions if remote diagnostics are required. Handle the module and fiber connectors with care to avoid contamination; keep protective caps on connectors when not in use and follow ESD precautions during installation.