Kuitulähetin-vastaanotinmoduuli BlueOptics SFPP-ER-BO 10000 Mbit/s 1550 nm

The BlueOptics SFPP-ER-BO is a single‑mode fiber optic SFP+ transceiver module designed for 10 Gbit/s networks. It operates at a wavelength of 1550 nm, supports LC duplex connections and comes in a metal housing with a nominal 3.3 V supply. The compact, lightweight module (approx. 2 g) is intended for high‑distance optical links and is compatible with hardware that supports 10GBASE‑ER SFP+ modules. It is suitable for use in switches, routers, storage systems and similar network equipment that accept SFP+ MSA‑compliant transceivers.

Advantages

The module provides a standard SFP+ interface with a maximum data transfer rate of 10000 Mbit/s and a 1550 nm transmitter/receiver pair for long‑reach single‑mode operation. The metal housing increases durability and thermal stability while the lightweight form factor simplifies installation and hot‑swap replacement. Compliance with MSA‑defined SFP+ pinout and LC duplex connector ensures interoperability with a wide range of network platforms. The transceiver also supports digital diagnostic monitoring (DDM/DOM) when supported by the host hardware, enabling remote monitoring of key optical and electrical parameters.

Suitable for

Key specifications

How to use

Install the BlueOptics SFPP-ER-BO by inserting the SFP+ module into an appropriate SFP+ port on compatible network equipment until it latches. Connect LC duplex single‑mode patch cords to the transmit and receive ports, observing correct polarity. Ensure the host device is configured for 10GBASE‑ER operation and that any required firmware or software settings allow third‑party SFP+ modules. If the host supports DDM/DOM, enable diagnostics to monitor supply voltage, laser bias, optical output/input power and module temperature.

Recommendations

Use high-quality single‑mode patch cords and, where possible, route fibers through patch panels to protect connectors. Verify compatibility with the specific switch or router model and enable DDM/DOM for proactive monitoring. Avoid excessive bending of fiber and operate the module within manufacturer‑specified temperature and voltage ranges to ensure long service life.