Kuituoptinen lähetin-vastaanotinmoduuli BlueOptics MCX0JXE51-BO SFP+ LC alumiini

The BlueOptics MCX0JXE51-BO SFP+ LC Aluminium is a fiber optic transceiver module designed for 10 Gbps multimode applications. Built in an aluminium housing and weighing approximately 20 g, this SFP+ module uses an LC duplex connector and follows MSA SFP+ form-factor standards to provide high-speed optical connectivity for compatible network equipment. The module supports 10GBASE-SR multimode transmission with an 850 nm wavelength and is intended for short-range fiber links.

Advantages

The transceiver offers compact SFP+ form factor compatibility for a variety of switches, routers and storage systems, and is manufactured to comply with common MSA standards for host interoperability. Its aluminium case provides physical durability while keeping the module lightweight. The design supports simultaneous transmit and receive over LC duplex multimode fiber and offers digital diagnostics monitoring (DDM/DOM) capability when supported by the host, enabling real-time status reporting for voltage, temperature, optical power and laser bias current.

Suitable for

Key specifications

How to use

Install the transceiver into a compatible SFP+ slot on your switch, router or storage device, ensuring the host device supports 10GBASE-SR SFP+ modules and DDM if diagnostics are required. Connect LC duplex multimode fiber patch cords to the module with correct TX/RX orientation. Configure the host interface according to the equipment vendor instructions and verify link status and diagnostics through the host management interface. Remove the protective dust caps from the module and fiber connectors before insertion and replace them when the module is not in use.

Recommendations

Use multimode fiber of appropriate grade (OM3/OM4 recommended for optimal 10G performance over longer short-range distances), keep fiber connectors clean using proper cleaning tools, and ensure firmware and driver compatibility on host equipment to maintain link stability and enable DDM functions.