Kupari-SFP-lähetin-vastaanotin BlueOptics 310-7225-BO 1250 Mbit/s Dell

The BlueOptics 310-7225-BO is a copper SFP transceiver module designed for 1000BASE-T Ethernet links with a maximum data transfer rate of 1250 Mbit/s. It features an SFP interface with an RJ45 physical connection and is compatible with Dell hardware platforms that accept the Dell 310-7225 module. The module is RoHS, CE and FCC certified and weighs approximately 20 g, offering a compact solution for short-range copper network connections.

Advantages

The transceiver provides standardized SFP interoperability and supports gigabit Ethernet transmission over twisted-pair copper cabling up to typical 100 m distances when used with appropriate cabling and hardware. It is manufactured to meet Multi-Source Agreement (MSA) mechanical and electrical form-factor standards, which helps ensure plug-and-play fit in SFP ports on compatible Dell equipment. Compliance with RoHS, CE and FCC indicates adherence to common environmental, safety and electromagnetic standards. The compact chrome-colour module and light weight simplify handling and installation in rack-mounted networking equipment.

Suitable for

• Gigabit Ethernet uplinks and switch interconnections in data centers and server rooms
• Upgrading or replacing SFP ports on Dell switches, routers and other compatible network devices
• Short-range copper connections over twisted-pair cabling (typical up to 100 m)
• Network hardware maintenance and field service replacement parts

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Connector type: RJ45 (copper twisted-pair)
• Typical reach: up to 100 metres over appropriate Cat5e/Cat6 cabling (dependent on environment and hardware)
• Product colour: Chrome
• Weight: 0.02 kg
• Regulatory standards: RoHS, CE, FCC

How to use

Insert the BlueOptics 310-7225-BO SFP transceiver into a compatible SFP port on Dell or other MSA-compliant networking equipment while the device is powered off or following the vendor's hot-swap guidance. Connect the RJ45 copper cable to the module and the remote device, ensuring correct cable type and good-terminals. Configure the host device as required for a 1000BASE-T link and verify link status using the switch or router management interface. If the host supports Digital Diagnostics Monitoring (DDM/DOM), enable and monitor available diagnostic parameters via the management interface when supported by the platform.

Recommendations

Use high-quality Cat5e or Cat6 cabling and proper RJ45 terminations for best link stability. Verify firmware and hardware compatibility with your Dell device before deployment and, where possible, test the module in a non-production environment. Store unused transceivers in anti-static packaging and avoid exposure to moisture or extreme temperatures.